Member Since: 21 Oct 2016
Location: kent
Posts: 13613
Erea wrote:
I presume those bolts are 8.8, Buy a similar size in your local hardware shop and test out your saw on it to see if it’s up to the job.
thks , that’s not a bad idea u know, pretty sure i’ve got some in the shed
now where did i leave my shed
Last edited by gstuart on 10th Jun 2018 10:48 am. Edited 1 time in total
10th Jun 2018 10:39 am
gstuart
Member Since: 21 Oct 2016
Location: kent
Posts: 13613
Kingmav66 wrote:
I don't know about the air-saw, but I used a 110v recip saw and had no problems. Slow, steady and plenty of cutting fluid was the key
still got some talon which i useto use when i cut up old galv cold water tanks , always hated it when the blades bit and ended up putting them in a vice to straighten them back out
got some penetrating oil which i will start applying a week before
seen some 14 & 24 Tpi blades, indeed as to whether i would be better with a higher or lower TPi
don’t think there’s enough room by the looks of it for an impact gun, just a ring spanner , got plenty of impact sockets , breaker bar, also an air chisel
just wanted to make sure i’ve got everything before hand
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum