Advertise on DISCO3.CO.UK
Forum · Gallery · Wiki · Shop · Sponsors
DISCO3.CO.UK > Maintenance & Mods (D3)

Amber 'rockin' rover light after snorkel install
Post Reply  Down to end
Page 1 of 1
Ruper
 


Member Since: 28 Jun 2019
Location: Virginia
Posts: 312

United States 2005 LR3 4.4 V8 SE Auto Maya GoldLR3
Amber 'rockin' rover light after snorkel install

Ok a couple things going on here. First I drove home for a visit from NC to VA, states of coarse. 80 degrees in NC, dropped to under 32 deg in VA cold front come through.
At the same time I installed a snorkel kit drilling holes in the A-pillar next to the Air bag of coarse.

The holes were some distance from the little plastic Air Bag label/marker, but I read another post here about this light possibly being tied to low air bag sys pressure.
So in my mind either the air susp. has moisture in the lines and it froze or I kicked the air bag or line supplying the air bag sys. when I drilled my holes.


Temps this AM are a little higher, than freezing so I plan to wait to start until temps are up today and see if I get a clean start. IF so it would seem to point moisture in system, possble compressor rebuild/Drier replacement.

Opinions?
 2005 Land Rover D3, 4.4L V8, Maya Gold Metallic
1966 Scout 800, 196 cu.in.
1975 Scout II, 392 cu.in. 
 
Post #209895911th Nov 2019 11:55 am
View user's profile Send private message View poster's gallery Reply with quote
sasdiscos
 


Member Since: 22 Feb 2013
Location: Northants
Posts: 885

United Kingdom 2010 Discovery 4 3.0 TDV6 HSE Auto Bali BlueDiscovery 4

Did you take the internal a pillar cover off when you drilled the holes?

Take it off and check, 2 min job.

Steve
 You remind me of a younger me, not much younger mind...perhaps even a little older!  
Post #209900011th Nov 2019 2:21 pm
View user's profile Send private message View poster's gallery Reply with quote
Ruper
 


Member Since: 28 Jun 2019
Location: Virginia
Posts: 312

United States 2005 LR3 4.4 V8 SE Auto Maya GoldLR3
A=pillar internal

No I did not remove the interior a pillar just the out.
So update, I went on the road Sunday to go shoot rifles with a friend. At the start of the trip I got the yellow rocking rover so we went along on the bumps with an every now and then a hard bump with tire rub. (I put on bigger tires and a lift kit)

Drove around 20 minutes and at a traffic light turned the key off and back on. No light everything went fine and has gone fine in that the cooler temps have subsided for now, however they will be back. I had no issues or lights while the weather returned to normal temps (Above Freezing of water 32 deg).

So now its got me thinking for sure I have some moisture in the lines, and now with the cooler temps ir condenses and then freezes over night.

Is there a moisture bleed somewhere at a low point drain?
I am ordering a Air Compressor kit with the desiccant material, however I won't return home for another month and have no where to do this work while out of town, much less the proper tools with me.

So anyone know how to drain excessive moisture out from the suspension system?
 2005 Land Rover D3, 4.4L V8, Maya Gold Metallic
1966 Scout 800, 196 cu.in.
1975 Scout II, 392 cu.in. 
 
Post #209932713th Nov 2019 9:03 am
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO3.CO.UK is independent and not affiliated to Land Rover.
Switch to Mobile Site