Member Since: 18 Jul 2017
Location: Teesside
Posts: 1
Another Suspension Topic
Apologies for yet another thread.
Long story short had on of failures of suspension for a couple of months followed by a couple of days of it only allowing normal ride height then total failure and on the bump stops. Got myself an IID tool and the suspension error is “C1A20-64 (6C) Pressure increases too slow when filling reservoir - Algorithm based failure - signal plausibility failure” The gallery pressure is only 40psi for the 20 sec the compressor stays on, the following picture is what I think is relevant
Showing pressure, relay and reservoir.
I then removed the hose from the compressor that supplies the reservoir via control valve, and i was able to stop the air from the compressor with my thumb.
I’m assuming by this that my compressor is goosed. If so do you by new or is it worth getting a service kit.
Service kit will give you a few months I did that then got a new one from AFRange Rover Westminster 4.4 TDV8 what a car
Discovery 3 HSE 2006 gone but never forgotten
Member of the 234,567 mile club😎
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum