Member Since: 05 Oct 2018
Location: Kent
Posts: 68
Can't you change just a wheel bearing?
I have a rumble yet to be diagnosed as FNS wheel bearing due to lack of time but when I eventually get under it and confirm either way my question is unanswered even after searching it out.
Can you change just the bearing or does it HAVE to be the full hub assembly? It will be a Timken item but i am looking to generally keep costs down so why change the entire hub if you can just change the bearing!?
19th Feb 2019 3:01 pm
sputnixb51
Member Since: 23 Apr 2013
Location: Morayshire
Posts: 833
Hub only, not a difficult job, unlike the rear bearings which is major work compared.
19th Feb 2019 3:12 pm
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20713
The bearing race is part of the hub assembly, hence a whole hub required My D3 Build Thread
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum