BigElk
Member Since: 22 Jul 2017
Location: Peoples Republic of Kent.
Posts: 60
|
I have the dreaded C1A13-64 fault code come up.
Is there a cut off point, IE from certain chassis number onewards where you can tell which make of compressor is fitted?
We have two D3’s both 2009 my, i wondered whether to get a new Comp and overhaul mine as a spare for both if they are interchangeable?
|
1st Jun 2018 8:47 am |
|
|
Grandadrob
Member Since: 21 Dec 2017
Location: Leominster
Posts: 279
|
I have a 59 plate D3, had a new compressor fitted yesterday. The fault on mine related to the compressor being too slow on first start, so it timed out, bringing up the fault.
My compressor was an Hitachi, so straight swap including relay.
I did ask about an upgrade, but was told that would require software upgrade. Mine was done under warranty, they would only pay for basic swap. Hope that helps.
Ido have the o,d one, are they difficult to repair ? 1955 SWB Series 1 86 inch
1960 SWB Series 2 88 inch
2009 Discovery 3 HSE Bournville Pearl
|
1st Jun 2018 10:52 am |
|
|