Vortech
Member Since: 08 Mar 2010
Location: Wusster
Posts: 29
|
Anyone know the best way to remove the door trim without damaging it? I think i've got a dodgy connection on the nearside door speaker.
Thanks in advance.
|
16th Jun 2010 1:08 pm |
|
|
GlosBoy
Member Since: 16 Oct 2009
Location: Chandlers Ford
Posts: 2444
|
Took mine off the other month to replace the window switch.
Pain in the butt. so many screws but once you have found then it comes off easily.
There are the obvious ones you can see plus a couple of hidden. One behind the LandRover badge and I think you have to take the handle off.
Only takes a couple of mins once you have identified the screws tho.
Only issue I had afterwards was the door handle (the bit your thumb presses) on the out side now hangs off.
Mark D4 HSE - Aintree Green
D4 Orkney my13 - gone
Stornaway D4. Gone, Didn't like it at all
D3 silver manual. Loved my first LR
_____________________________________________________
|
16th Jun 2010 1:24 pm |
|
|
Iain G
Member Since: 31 Jan 2009
Location: Filey
Posts: 430
|
Taken from a section in the WIKI on replacing front door latches:
1. Remove the various covers that conceal screws.
Use a flat bladed screwdriver to ease off 2 of the 4 clips on the grab handle cover. You will see access holes for these 2 clips if you look underneath the grab handle. The cover needs to be prised off in an upward direction. The Land Rover badge (located towards the upper rear of the door) simply pops out using a screwdriver, as does the round cover located behind the door release handle.
2. Remove door card.
Undo the 4 screws holding the grab handle. Undo the screw at each end of the storage pocket at the bottom of the door. Remove the screw from behind the Land Rover badge and behind the door release handle.
The door card now is only held in by clips, all of which are released by pulling the door card straight off the door (not in an upward or downward direction), start at the lower corners. The upper tweeter triangle section is part of the door card and has a small clip that releases fairly easily. You may now need a second person to hold the door card while you remove the various wiring connectors. Disconnect the door release cable by undoing the catch at the cable end of the mating.
|
16th Jun 2010 8:48 pm |
|
|
Renton
Member Since: 13 Jan 2009
Location: Somewhere in the middle
Posts: 1718
|
If you send me a PM with your email I can send you a instruction. CLUB ILLEGAL CAR WASHERS
|
16th Jun 2010 10:02 pm |
|
|
Vortech
Member Since: 08 Mar 2010
Location: Wusster
Posts: 29
|
Thanks for this!
Renton,
have sent you a pm.
|
16th Jun 2010 10:14 pm |
|
|
mik
Member Since: 08 Feb 2010
Location: Skoatland
Posts: 912
|
There are links to images in my thread here.
|
17th Jun 2010 1:05 pm |
|
|