Advertise on DISCO3.CO.UK
Forum · Gallery · Wiki · Shop · Sponsors
DISCO3.CO.UK > Webasto Fuel Burning Heater

FBH protocol by CAN network
Post Reply  Down to end
Page 1 of 1
KING2
 


Member Since: 25 Feb 2022
Location: Moscow
Posts: 10

Russia 2007 Discovery 3 TDV6 HSE Auto Buckingham BlueDiscovery 3
FBH protocol by CAN network

Hi!

I have D3 with Webasto and 1533 timer fitted (russian climate pack), so Webasto can be run from 1533 timer (now I have cheap chinese car alarm just emulating pressing timer button, to turn pre-heater on and off - just as temporary solution).

But if you have D3 woken up (multimedia screen is lighting) you cannot turn Webasto on - it tried to start and immediately goes off. This means if you start АИР to heat a car, you should wait until it will heated up, not opening the car (but maybe I want to place something into a car and I want Webasto to run until I will start the car, not just open it).

As I understand, car's CAN bus contains some messages that turns off everything commanded over W-Bus, so I decided to make some research, maybe it is possible to send commands to Webasto over CAN network instead of W-Bus?

Maybe somebody made something about this and can share something with me?
Message IDs, protocols, fields, or something, just not to start from empty place?

Thank you in advance!
  
Post #228085426th Feb 2022 1:56 pm
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO3.CO.UK is independent and not affiliated to Land Rover.
Switch to Mobile Site