steve smith
Member Since: 11 Mar 2008
Location: up north towards the hills.
Posts: 2427
|
I need to remove the Floor from my G4 rack but it appears to be fixed in the middle somewhere any idea's for removal?
cheers all Steve
|
14th Dec 2009 5:21 pm |
|
|
MrH
Member Since: 08 Aug 2007
Location: lost in the forest
Posts: 7754
|
Gas torch? LRs are a fond memory, apart from the maintenance.
|
14th Dec 2009 5:40 pm |
|
|
steve smith
Member Since: 11 Mar 2008
Location: up north towards the hills.
Posts: 2427
|
Mr H, there is no need to be that dramatical i am sure it's just a nut and bolt somewhere Steve
|
14th Dec 2009 5:45 pm |
|
|
MrH
Member Since: 08 Aug 2007
Location: lost in the forest
Posts: 7754
|
Well you didn't say it needed to be re-useable
Not sure, but it could be similar to the way I fitted the 2-piece floor to my old G4 rack the first time, it was bolted on the outer edges and hooked under a fastner down the middle. This meant you only need to undo the out edge bolts to lift it off and then once both bits of floor were removed I could undo the centre fastners.
In the end I just put an extra set of lashing eyes with big washers down the joint and that did the trick just as well. LRs are a fond memory, apart from the maintenance.
|
14th Dec 2009 6:34 pm |
|
|