In my long on going quest to fit front parking sensors, I'm looking for the connector between the front harness and the main harness I think it's connector C2243/C2245. I have the module in the rear of the car and the cable running from that to some where in the front of the car. I'm missing the cable from the front foot well area (I believe it some where near the CJB or pasanger foot well area) to behind the head light. So looking at the wiring diagram I need to find the connector C2243/C2245. Not sure how clear the photo will come out but from what I can make out I have the module and the first section of wiring, I'm missing the second section and the third section should be the bumper wiring harness.
Anyone got any ideas where this is??
Cheers
Nick
14th Mar 2015 1:04 pm
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20713
I believe it's up behind the CJB or base of the A pillar.
Much easier to find the wiring in the footwell, and splice into it My D3 Build Thread
Member Since: 10 Sep 2012
Location: Northampton
Posts: 1034
Located behind the passenger compartment fusebox
Click image to enlarge
There's a PDF in my gallery with the connector description
http://www.disco3.co.uk/gallery/albums/use...C2243R.pdfGAP IID Pro Multi Vehicle Defender L316 2007-2015 - Discovery 3 - Discovery 4 - Discovery Sport L550 - Freelander 2 - Range Rover Evoque L538 - Range Rover L322 - Range Rover L405 - Range Rover Sport L320 - Range Rover Sport L494 Electrical Fault Diagnostics
I was hoping not to have to remove the CJB but if I want parking aids guess I'll have to have a dig around and have a look
14th Mar 2015 2:09 pm
ArtasL
Member Since: 26 Oct 2017
Location: Kaunas
Posts: 1
Hello, did you found the place there C2243R/C2245R is located? Do you have working front pdc at the moment? Was is just matter of connecting those two plugs together?
Yes I did find the connector. Not to difficult to find. Just remove the lower panel below the glove box. Then look up behind the CJB and carefully wriggle it out enough to work on. I brought a main engine bay loom for £30 from a breakers. Removed all the plastic coating, traces the six wire I needed back from the front parking sensor plug to the C2243R connector and made up a separate loom.
Once I made the separate loom I’ve run it from the OSF headlight up to the second battery box over the engine, through the plastic channel then through the main grommet behind the battery and fuse box then repinned it into the existing loom. I haven't had time to activate the sensor or fit them yet but will be done soon the will let you know how I get on.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum