Spannerman
Member Since: 13 Feb 2010
Location: woodford green
Posts: 16
|
Heater Matrix problem(blocked up) |
|
Help needed!Heater matrix pipes are both hot , & I have replaced the thermostat & I have no fault codes
meaning the blend motors etc. are ok. I am preparing to reverse flush the Heater Matrix & wondered if anybody has had any luck in carrying out this process.With regards to reverse flushing the matrix has anybody used any particular flushing agent with any degree of success like Wynn's, Forte ect? I was going to use mains pressure garden hose ,has anybody used a Gates / HeCat 91002 flushing gun with anymore success ?My matrix I am fairly confident is to blame here, just about luke warm air from the N/S drivers vent & on increasing the fan speed it blows cold again. If finally I do need to replace the Matrix does anybody know of any good You-tube clips showing procedure for replacement? I have read a thread about cutting a piece of plastic to allow a less complicated removal does anybody have any info on removal of the matrix? I am reticent to attempt removal , as there are no leaks at present & have read that the O rings & pipes can be a bitch to line up and quite often leak after replacement . Does anybody know if the entire centre-consul needs to be removed?Has anybody removed & refitted it easily?
|
3rd Jan 2020 2:09 pm |
|
|
|
Oswiperus
D3 Decade
Member Since: 02 Apr 2010
Location: Chelmsford, Essex
Posts: 1590
|
https://disco3.co.uk/forum/heater-issue-180746.html
Stu
2016 D4 Landmark current
2022 Defender D300 SE Gone
D4 2014 XS Commercial - Gone
D4 2016 hse lux montalcino red - Gone
D3 2005 se java black - current
D3 2005 base manual - gone
D2 1999 TD5 E white - current
|
3rd Jan 2020 2:41 pm |
|
|