Member Since: 06 Nov 2006
Location: Bristol
Posts: 519
HELP: Advice on where to fit the remote FBH cable
I bought the receiver and cable from TLO for MY12 HSE so I can get the remote Fuel burner heater going.
Click image to enlarge
I have the car in bits, but cannot see where to plug the other end of the cable (purple connector). I can clearly see where the receiver goes. Anyone know where it goes? Or have I bought the wrong part!
Thanks in advance
2nd Feb 2013 3:01 pm
geoff.
Member Since: 24 Jan 2010
Location: West kent
Posts: 8531
nic
sent you a message
2nd Feb 2013 3:15 pm
RichardB
Member Since: 04 May 2010
Location: Hants
Posts: 485
Geoff may have given you the info but in case...
The unit fits behind the right panel area in the boot area (jack side). There is a plug wrap pec in light grey foam tucked about midway on the wiring loom bundle that runs along that section near the bottom. Airial, I ran up inside of C pillar sticking it to the black glass there so that it invisible inside the trim.
2nd Feb 2013 3:39 pm
NicSymonds
Member Since: 06 Nov 2006
Location: Bristol
Posts: 519
Thanks RichardB, yes I've spoken to Geoff. Looks easy enough now especially when I get the right part. Ah well!
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
for MY12 HSE so I can get the remote Fuel burner heater going.
