Matty 2332
Member Since: 02 Dec 2008
Location: West Yorkshire
Posts: 670
|
Following the recent failure of my EPB I unplugged the connector from the EPB module and discovered two loose green / yellow wires, I also noticed two empty holes in the connector positions G1 & H1. I plugged them back in what I thought were the correct holes turned ignition ,and everything lit up with bongs. Now got the HDC fault, engine fault, suspension lowered, E in the gear display (manual transmission) hazards and it wont start. I disconnected the wires and still get all the warnings and still wont start. I have disconnected and reconnected the battery and still all as above. Any ideas ???
Many thanks
|
17th Feb 2010 1:37 pm |
|
|
grzesiul
Member Since: 11 May 2008
Location: UK
Posts: 6266
|
how long have you disconnected battery for?
give it at lease 20 min for reset
|
17th Feb 2010 1:52 pm |
|
|
PaulP
Member Since: 04 May 2007
Location: Barcelona
Posts: 4317
|
When you say EPB module, you don't mean the EPB switch connector by any chance?
I'm probably way off the mark, but I've previously had the centre console cover off and got this problem when I had forgotten to connect something back up - can't remember if it was the EPB swich or the Terrain Response panel... 2006 Discovery 3 TDV6 SE Auto Buckingham Blue
2007 Golf GT DSG
|
17th Feb 2010 1:54 pm |
|
|
Matty 2332
Member Since: 02 Dec 2008
Location: West Yorkshire
Posts: 670
|
Thanks chaps, the connector is on the module itself (above the diff). I only disconnected the battery for a couple of minutes though so I will go give it half an hour.
Thanks again
Matt
|
17th Feb 2010 1:59 pm |
|
|
Matty 2332
Member Since: 02 Dec 2008
Location: West Yorkshire
Posts: 670
|
All sorted now - reason for shutdown was that i had not pushed fully home the EPB module connector Durrrrrrrrr
|
17th Feb 2010 4:01 pm |
|
|