Advertise on DISCO3.CO.UK
Forum · Gallery · Wiki · Shop · Sponsors
DISCO3.CO.UK > Maintenance & Mods (D3)

Howto: Dr Tranny
Post Reply  Down to end
Page 3 of 5 <12345>
disco4ever
 


Member Since: 23 Dec 2013
Location: under the car
Posts: 402

Germany 2012 Discovery 4 3.0 SDV6 HSE Lux Auto Santorini BlackDiscovery 4

@ bsm

the hose is of 10 mm inner dia. , just changed the auto fluid thru this connection into the cooler


 Achim

own garage certified LR tech

Disco 2 TD5 MY 2001 - gone but still driven by another owner
Defender 110 TD5 driving me bananas with all faults
Disco 3 TDV 6 HSE MY 2005 gone @280.000 km
Disco 4 SDV 6 HSE MY 2012 
 
Post #132295110th Aug 2014 7:03 am
View user's profile Send private message View poster's gallery Reply with quote
armybuck041
 


Member Since: 05 Dec 2009
Location: Canada
Posts: 30

Canada 2005 LR3 4.4 V8 SE Auto Bonatti GreyLR3

Precisely what I did as well.

Not sure if the cooler in the Petrol V8 is different TDV6, but I had no trouble adding 7 litres of Lifegard 6 through the upper cooler line using clear tubing and a funnel. All I had to do was occasionally squeeze the clear tubing to keep the fluid moving, but the whole flush took a little over 30min once all of the lines were connected and I figured out what line was what.

For those with the Petrol V8, the top spigot coming off of the fluid cooler is the outflow from the cooler back to the gearbox. I simply unplugged the rubber line and stuffed 3/8" clear tubing into it and tightened the clamp. This was where I added the new fluid via the funnel. I then attached clear tubing onto the spigot and ran it into a 5 litre container with a lid. No pics, but I cut a hole large enough for the clear tube to fit through the lid, passed the tube through and then put a cable tie around the tube so that the force of the fluid coming out didn't cause the tube to pop out and spray as mentioned by others. I screwed the lid down and then used the clear sight line on the jug to keep an eye on how full it was.

I ran the engine long enough to get 4.5 litres into the jug (15 seconds), then added 5 litres through the funnel. I ran the engine again to get an additional couple litres out of it, and then added the remaining 2 litres for a total of 9 litres. I then did the fluid levelling as per the Shop Manual using my IIDTool to monitor the fluid temps. If you overfill it a little bit when doing the flush, you can avoid having to add fluid during the levelling. I just waited until the fluid hit 31*c and crawled underneath and popped the check plug and let it drain until it was down to a thread coming out (approx 200ml).

I had originally drained 4 litres through the pan but could only add 2 litres back with through the fill plug before it started coming out the hole. Next time I do this, i'll drain the pan and then add fluid solely through the cooler line as adding through fill plug is a pain in the ass. I figure in a years time i'll do this again and it should only take an hour.
 2005 NAS SE Petrol V8  
Post #132322310th Aug 2014 4:22 pm
View user's profile Send private message View poster's gallery Reply with quote
therso
 


Member Since: 01 Dec 2010
Location: Here!
Posts: 368

United Kingdom 2014 Discovery 4 3.0 SDV6 HSE Auto Corris GreyDiscovery 4

Just about to contact a recommended gearbox specialist to get the damned thing sorted, then pause! Okay, I'll give this Tranny stuff a shot. Physically I can't tackle the underneath option but I'll have a go under the bonnet. So when I've posted this I'll order the stuff. The thing is, just as I get the idea about disconnecting a hose and squeezing(?) the stuff in which takes a while someone comes along a suggests using a syringe, attaching another bit of hose etc, THEN the next thing I see is a photo of some garden spray device with clear tubing and we're of into the world of hose lengths, internal dimensions and more....I'm old, I've got a drive and a garage full of 'stuff' (why the Censored she insists on keeping that Censored bike that she hasn't ridden in 8 years must be kept 'just in case' beats me...'Dump it, woman FFS!!') Sorry, I digress but I'm pretty sure you'll understand. I mean she won't Censored get rid of anything and I'm the bloody idiot who keeps having to shift it around when I'm trying to have a clear out! Now where was I? Oh yes. Any chance of an idiot's guide? It's the medication you see............. Big Cry
  
Post #132822622nd Aug 2014 12:39 pm
View user's profile Send private message View poster's gallery Reply with quote
therso
 


Member Since: 01 Dec 2010
Location: Here!
Posts: 368

United Kingdom 2014 Discovery 4 3.0 SDV6 HSE Auto Corris GreyDiscovery 4

Sussed it. Doh! Rolling Eyes
  
Post #132825122nd Aug 2014 1:31 pm
View user's profile Send private message View poster's gallery Reply with quote
raptor_uk
 


Member Since: 09 Aug 2013
Location: durham
Posts: 26

United Kingdom 

Do it at the cooler but not the hose
Raptor_UK wrote:
anybody any pics of the location of THIS hose
 

Last edited by raptor_uk on 26th Aug 2014 12:26 pm. Edited 1 time in total 
Post #132972426th Aug 2014 11:01 am
View user's profile Send private message View poster's gallery Reply with quote
bsm
 


Member Since: 14 May 2012
Location: Ellikom
Posts: 232

Belgium 2008 Discovery 3 TDV6 HSE Auto Alaska WhiteDiscovery 3

Nice summary raptor_uk. Thumbs Up
 2017-...: Disco II Td5 auto, 1999, BAS remap, HD TC and auto box Ashcroft, Allisport IC, ACE, 2" lift only coils, BF goodrich KM2 265/70R17, FF front and rear bumper, TF steering guard and tree sliders, nanocom.
2013-2017: Disco 3 TDV6 HSE aut. of 2008, Britpart treesliders, IIDTool, RLD sump guard, BFG KM2 265/70R17, adj. rods, BAS remap + EGRs blanked, silicon IC hoses.
2010-2013: Disco II Td5 of 2000, ACE, front Bearmach HD coils, rear SLS, GG AT2
 
 
Post #132977126th Aug 2014 12:23 pm
View user's profile Send private message View poster's gallery Reply with quote
bsm
 


Member Since: 14 May 2012
Location: Ellikom
Posts: 232

Belgium 2008 Discovery 3 TDV6 HSE Auto Alaska WhiteDiscovery 3

Experiencing shudder and slip, again. Going for a mega flush tomorrow.
Is it a good idea to add Dr. Tranny immediatly after the flush? Or is the flush with cleaning procedure enough and is adding the stuff a waste of money so I better keep my tube for later when the judder/slip comes back?
 2017-...: Disco II Td5 auto, 1999, BAS remap, HD TC and auto box Ashcroft, Allisport IC, ACE, 2" lift only coils, BF goodrich KM2 265/70R17, FF front and rear bumper, TF steering guard and tree sliders, nanocom.
2013-2017: Disco 3 TDV6 HSE aut. of 2008, Britpart treesliders, IIDTool, RLD sump guard, BFG KM2 265/70R17, adj. rods, BAS remap + EGRs blanked, silicon IC hoses.
2010-2013: Disco II Td5 of 2000, ACE, front Bearmach HD coils, rear SLS, GG AT2
 
 
Post #13335973rd Sep 2014 8:51 am
View user's profile Send private message View poster's gallery Reply with quote
Wilko_UK
 


Member Since: 04 Jul 2014
Location: Gloucestershire
Posts: 16

United Kingdom 2013 Discovery 4 3.0 SDV6 HSE Auto Indus SilverDiscovery 4
Dr Tranny Done...

I was starting to get shudder whilst towing, stuck in traffic and pulling up a hill. This was after a fluid and filter change. Just put a tube of Dr T in this morning, quick drive and it feels even better than before. Towing again this afternoon, will let you know the outcome.

Best Wishes,
  
Post #13349625th Sep 2014 12:09 pm
View user's profile Send private message View poster's gallery Reply with quote
raptor_uk
 


Member Since: 09 Aug 2013
Location: durham
Posts: 26

United Kingdom 

I've put two tubes in, gearbox method with rh side jacked up.
Towing, driving is better than ever.. how long will it last Confused
  
Post #13349675th Sep 2014 12:15 pm
View user's profile Send private message View poster's gallery Reply with quote
Wilko_UK
 


Member Since: 04 Jul 2014
Location: Gloucestershire
Posts: 16

United Kingdom 2013 Discovery 4 3.0 SDV6 HSE Auto Indus SilverDiscovery 4
An additional tip

I don't know if you guys have done this already, but I found it quite difficult to get at the top cooler hose. If you remove the thick black air box pipe first it makes getting at the top hose a lot easier. However, remember to re-seat the rubber 'washer' correctly onto the intake pipe, otherwise the next time you drive through knee-deep water you could pull water into the engine.. never a good idea that.
  
Post #13349785th Sep 2014 12:41 pm
View user's profile Send private message View poster's gallery Reply with quote
Ste69winz
 


Member Since: 10 Dec 2014
Location: Wolverhampton
Posts: 3

United Kingdom 2006 Discovery 3 TDV6 Base 7 Seat Auto Buckingham BlueDiscovery 3

dub01s wrote:
Do it at the cooler but not the hose. I assume the hose has a valve in it that stops/slows the fluid flowing back down the hose. No such problem with the cooler itself. Take the hose off the cooler keep it raised get a small piece of spare hose on the cooler pipe and add dr.t straight to the cooler. Goes straight in as quick as you can empty the tube. Put the cooler hose back. Job done. 2 minutes!


Do you mean squirt dr tranny straight down the cooler hose as directed in the picture supplied on this thread.
  
Post #138717710th Dec 2014 9:43 pm
View user's profile Send private message View poster's gallery Reply with quote
bsm
 


Member Since: 14 May 2012
Location: Ellikom
Posts: 232

Belgium 2008 Discovery 3 TDV6 HSE Auto Alaska WhiteDiscovery 3

Yep! 2nd picture on the first page, not in the hose but directly in the cooler with an extra little hose.
 2017-...: Disco II Td5 auto, 1999, BAS remap, HD TC and auto box Ashcroft, Allisport IC, ACE, 2" lift only coils, BF goodrich KM2 265/70R17, FF front and rear bumper, TF steering guard and tree sliders, nanocom.
2013-2017: Disco 3 TDV6 HSE aut. of 2008, Britpart treesliders, IIDTool, RLD sump guard, BFG KM2 265/70R17, adj. rods, BAS remap + EGRs blanked, silicon IC hoses.
2010-2013: Disco II Td5 of 2000, ACE, front Bearmach HD coils, rear SLS, GG AT2
 
 
Post #138718210th Dec 2014 9:53 pm
View user's profile Send private message View poster's gallery Reply with quote
Ste69winz
 


Member Since: 10 Dec 2014
Location: Wolverhampton
Posts: 3

United Kingdom 2006 Discovery 3 TDV6 Base 7 Seat Auto Buckingham BlueDiscovery 3

Ok im just a little wary of this as me and my partner dont want to mess anything up
  
Post #138718610th Dec 2014 10:09 pm
View user's profile Send private message View poster's gallery Reply with quote
irish nigel
 


Member Since: 30 Dec 2014
Location: Swindon
Posts: 14

United Kingdom 2006 Discovery 3 TDV6 HSE Auto Java BlackDiscovery 3

I crawled under the gearbox today, didn't fancy that! I got a 50ml syringe a length of earthwire sheathing, took the cooler hose off, fed the sheath/tube into the cooler directly as previously described, poured dr tranny into the syringe and gravity did the rest. 10 minutes!!

I have to say I'm sceptical about these additives but I went out for a drive and I was amazed. No judder and smooth quick gear changes. I'll post a pic tomorrow of the syringe setup.

I will still have a mega flush done with Geoff in the near future for peace of mind.
  
Post #143330825th Feb 2015 10:10 pm
View user's profile Send private message View poster's gallery Reply with quote
vlonjati
 


Member Since: 24 Jun 2016
Location: North West
Posts: 14

United States 2005 LR3 4.4 V8 HSE Auto Maya GoldLR3

Pardon hitting up an old thread but can you tell me how has this paned out in the long run?
Thanks
  
Post #16755091st Jul 2016 6:18 am
View user's profile Send private message View poster's gallery Reply with quote
Display posts from the last:  
Post Reply Back to top
Page 3 of 5 <12345>
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO3.CO.UK is independent and not affiliated to Land Rover.
Switch to Mobile Site