| Home · FAQ · New Posts · My Posts · PMs · Search · Members · Members Map · Groups · Profile · Donate ·
Log In
|
- You are currently viewing DISCO3.CO.UK as a guest - Register to take part or Log In
oradba69
Member Since: 26 Feb 2010
Location: Centurion
Posts: 39
  
|
I got myself one of above mentioned tools and was wondering on the suspension height what other users have saved as pre-sets?
I have programmed my second saved setting to be 20mm higher all-round but have noticed in very warm weather it takes forever to reach off-road height. Any suggestions?
I was thinking to use my 1st preset as my on-road setting and maybe go for a -5mm setting. Good/bad idea? Will I need to redo wheel alignment?
Apologies for all the questions.
|
 12th Nov 2013 6:45 am |
|
|
M3DPO
Member Since: 22 Sep 2010
Location: Notts.
Posts: 8112
 
|
I'm running -10 no problem, slow lifting is no connection to the Iid tool. There does seem to be a limit to how low you can go and still use access height, I have tried -20 and when you go into access height it hit the bump stops and raises to off road height. It can when others can't,
It will when others won't,
It goes where others don't.
|
| 12th Nov 2013 10:38 am |
|
|
D4JWW
Member Since: 20 Oct 2009
Location: London, UK
Posts: 1318
 
|
oradba69 wrote:I got myself one of above mentioned tools and was wondering on the suspension height what other users have saved as pre-sets?
I have programmed my second saved setting to be 20mm higher all-round but have noticed in very warm weather it takes forever to reach off-road height. Any suggestions?
I was thinking to use my 1st preset as my on-road setting and maybe go for a -5mm setting. Good/bad idea? Will I need to redo wheel alignment?
Apologies for all the questions.
Agree with M3...speed of raising has to do with hot weather and the compressor saving it self by raising slowly because of the software preventing over heating it's worth running the test section on IIDTOOL and see what temp the compressor is running at when this happens?
Ref wheel alignment I run on tar roads -20 lower and selected this on the wheel alignment rig and recorded before and after the different ride heights and was surprised that the values was within range. In extra height mode I'm sure you won't be driving that far with this selected so not really an issue either? A few mods... and keeping it all running...Faultmate MSV2
MY09EGR's blanked Thanks Bellautos, BAS
|
| 14th Nov 2013 9:59 pm |
|
|
IndusD4
Member Since: 01 Dec 2011
Location: Sydney, NSW
Posts: 308
|
I have +20, +40 and +49 - the latter being as high it would change up to in one go. Not sure why I set +20 and +40 as haven't used these settings. As I use mine off road, I change to +49, which is about the same as changing the suspension to off road setting. Then when I need more clearance I'll use the suspension "off road" setting.
Ron
|
| 15th Nov 2013 6:34 am |
|
|
|
Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
|
|
DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
|
|
DISCO3.CO.UK is independent and not affiliated to Land Rover.
