lee1970
Member Since: 15 Feb 2013
Location: wilts
Posts: 13
|
Hi all my 2006 d3 has the left indicator staying on all the time , flashing rate normal, new switch fitted still the same, possible cjb fault?. All wiring. Checked out good from switch to cjb.
Only getting 6.6 volts out cub all time, 12 volt out of right hand indicator.
|
 19th Oct 2019 9:12 pm |
|
|
Globetrotter448
Member Since: 21 Mar 2017
Location: Londonderry NSW
Posts: 1782
  
|
Check rear bulbs on the side that is not working - need to remove them as some have shown to be faulty.
|
| 20th Oct 2019 5:51 am |
|
|
Gareth
Site Moderator
Member Since: 07 Dec 2004
Location: Bramhall
Posts: 26701
|
This sounds similar to an issue I had a couple of years ago on my 4.
It started with the right hand front indicator remaining on all the time, even when the car was turned off and locked! It also has an afs warning light come on. It happened after washing the car
Eventually traced to damaged wiring in the loom behind the headlamp. I had to take out the headlamp and the wheel arch liner to access the loom as it came around the the chassis from the engine bay.
I had to cut off all the insulation wrap to expose wires and I found them damaged in the plastic shroud that is taped into the loom to guide it around the corner of the chassis. It looked like there had been a short as a few wires were melted together.
Once I found it, it was a simple fix with a soldering iron and some shrink wrap. When the dealer had it they couldn’t fix it.
I’ll try and dig up the thread.
|
| 20th Oct 2019 7:27 am |
|
|
