MercuryMog
Member Since: 06 Nov 2015
Location: Home Counties
Posts: 9
  
|
Has anyone removed the interior trim from around the gear-selector knob?
I assume the 'bright silver' trim around the knob itself needs to be pried upward, which will then allow you to remove the larger dark grey plastic trim?
There are a couple of deep scratches on the darker grey trim and I'd like to replace this piece. Before I make a mess of it, I hoped someone had given it a go and saved me the aggravation of treading new ground and leaving a trail of DIY disaster in my wake. 
Not my photo but this is the piece I mean:-
|
 30th Nov 2015 4:41 pm |
|
|
Russell
Member Since: 24 Aug 2007
Location: Kent
Posts: 10564
|
Think it is screwed in from under neath. Remove the cup holder and the trim panel underneath, then undo the two screws and from there the panel lifts out as a whole from memory, you can then get to the trim underneath MY17 D5 1st Edition Namib Orange
MY15 D4 HSE Kaikoura Stone
MY12 D4 HSE Nara Bronze Sold and gone
MY11 D4 HSE Stornaway Grey Sold and gone
D3 S spec Silver Sold and gone
Tow bar, full length roof bars, side steps, tow bar storage unit, surround camers.
D4 camera club
|
| 1st Dec 2015 1:18 am |
|
|
MercuryMog
Member Since: 06 Nov 2015
Location: Home Counties
Posts: 9
|
Thanks Russell - as it has to go back into the dealer for a few issues, I'll let them deal with it.
|
| 4th Dec 2015 10:51 am |
|
|
