Advertise on DISCO3.CO.UK
Forum · Gallery · Wiki · Shop · Sponsors
DISCO3.CO.UK > Faults & Fixes (D4)

Intermittent Suspension Fault - Amber and occasionally Red
Post Reply  Down to end
Page 2 of 2 <12
spiderlane
 


Member Since: 17 May 2017
Location: London
Posts: 94

2010 Discovery 4 3.0 TDV6 HSE Auto Buckingham BlueDiscovery 4

Hi Johnny

I was getting intermittent "Normal Height Only" warnings. I have just replaced the dryer filter/desiccant/cap as described here and so far no more of those messages (although a little too early to declare it fully fixed yet)

https://www.disco3.co.uk/forum/servicing-c...86453.html

Cheers
Mark
  
Post #212032611th Feb 2020 4:50 pm
View user's profile Send private message View poster's gallery Reply with quote
spiderlane
 


Member Since: 17 May 2017
Location: London
Posts: 94

2010 Discovery 4 3.0 TDV6 HSE Auto Buckingham BlueDiscovery 4

Oh and just to add, you'll probably save yourself a load of money on diagnosis in the long run by getting an IIDTool so you can see exactly what the car thinks is wrong for any given fault

I got mine from here : https://www.island-4x4.co.uk/integrated-in...27303.html

Not cheap but a brilliant bit of kit which has already paid for itself

Good luck
Mark
  
Post #212032711th Feb 2020 4:52 pm
View user's profile Send private message View poster's gallery Reply with quote
Dazz360
 


Member Since: 03 Sep 2016
Location: West Mids Walsall
Posts: 871

United Kingdom 2005 Discovery 3 TDV6 HSE Auto Bonatti GreyDiscovery 3

I see you are saying the ride height is good but have you measured it on flat ground from centre of wheel hubs to top of arch and compared the dimensions at standard ride height
 Metal auto sump & fluid change (3 hrs)
LR door puddle projectors (10 mins)
Tinted Bonnet wind deflector (10 mins)
All Intercooler pipes and Tbolts (2hrs)
3 injectors replaced so far (30mins)
Sunroof drain pipes both sides 2.5 hrs)
Rear discs, shoes,pads,callipers,flexi hoses, rigid brake line, n/s upper hub carrier bush and rear n/s upper arm (13hrs over 2 days) 
 
Post #212043411th Feb 2020 10:18 pm
View user's profile Send private message View poster's gallery Reply with quote
Johnny V
 


Member Since: 15 Mar 2019
Location: Daventry
Posts: 56

United Kingdom 2012 Discovery 4 3.0 SDV6 HSE Auto Nara BronzeDiscovery 4

Thanks both - will see what the dealer makes of it all - in particular the cap
No I haven't personally checked the ride heights as had left this to the LR specialist - all I can see is that the car 'levels' itself on my sloping (in two directions drive) as far as it can, then when used and parked on level ground it looks to have same clearance on wheel arches both when it is 'Ok' and when it says 'Normal Height Only"
When it is ok I can select Access or Off Road height with no problem - car raises and lowers the same as it did when it was brand new - when it goes to Normal Height though the selector is also disabled.
Just a frustrating gremlin that on top of the engine failure is a cost I could do without - maybe I should invest in a diagnostic reader !
  
Post #212051112th Feb 2020 10:08 am
View user's profile Send private message View poster's gallery Reply with quote
Johnny V
 


Member Since: 15 Mar 2019
Location: Daventry
Posts: 56

United Kingdom 2012 Discovery 4 3.0 SDV6 HSE Auto Nara BronzeDiscovery 4

By the way Spierlane followed your links re the replacement job - very impressive !
Must be honest and say as a mechanic I make a great sales manager - think this is one that I will leave to the experts as I reckon I could make things worse !
Really appreciate the ideas though as its possible the LR specialist may not think of this one
  
Post #212051312th Feb 2020 10:19 am
View user's profile Send private message View poster's gallery Reply with quote
cabhappy
 


Member Since: 14 Apr 2012
Location: BH20 7PA
Posts: 9

United Kingdom 2006 Discovery 3 TDV6 S Manual Zermatt SilverDiscovery 3
suspension fault

disco 3 would show suspension warning and lower suspension.
temporary fix, turn off ignition, wait a few moments restart, vehicle resets itself,
no pattern to problem.
it was solved by independent land rover garage.
a reset of front wheel alignment sensor done on diagnostics,when the wheels were in the straight ahead position, the system was detecting the front wheels were not in the straight ahead position.
This created a conflict in the electronics, so after a while the system declares a fault, and lowers the suspension.
reset wheel alignment, so actual wheel position and sensor reading the same, never had the fault, warning again.
 Just cabhappy  
Post #214641915th May 2020 7:13 pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
Sea Raider
 


Member Since: 01 Nov 2016
Location: None
Posts: 4450


^^^^presume you mean the steering angle sensor calibration^^^^

Takes 2 mins with the GAP IID tool
  
Post #214642115th May 2020 7:15 pm
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 2 of 2 <12
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO3.CO.UK is independent and not affiliated to Land Rover.
Switch to Mobile Site