Member Since: 08 Mar 2016
Location: South Bucks
Posts: 551
Loss of gears after autostart
Hi
I've got an MY16 Graphite and all is going well. I did have one issue recently though, and was wondering if anyone else has had this or has any advice.
I started the car after visiting a shop. I pulled up to the car park exit and had to stop to wait for a gap in the traffic. During this time the engine automatically stopped. I pressed the ECO button as I hate the stop/start, and the engine started up. A gap appeared and I pulled out. I got half way out and lost all drive. Engine was running and revved when I pressed the accelerator, but no drive. The car was in D but I couldn't change the gear selection using the rotary gear selector.
I switched the engine off and on again, and away I went.
I have read the error log using the BT IID tool but nothing showing.
Any ideas?
Cheers
PDMY16 D4 Graphite in Loire Blue
20th Aug 2016 9:31 pm
galwaygreen
Member Since: 30 Oct 2011
Location: plymouth
Posts: 6525
back to dealer
21st Aug 2016 1:35 am
trevorb1
Member Since: 21 Mar 2015
Location: Nuneaton
Posts: 62
Known issue after eco stop, requires transmission control module re-flash, there is a TSB for it.
21st Aug 2016 7:59 am
crews control
Member Since: 18 Mar 2007
Location: Dorset
Posts: 5011
I've had a couple of weird occasions where turning the ECO off (to keep the engine running) just as it decides to stop, confuses the system into turning off the engine completely. What's totally embarrassing is you don't realise this until you try to pull away... nothing. And then you can't start the car until you drop into park and put your foot on the brake. Makes you look like a serious numpty as everyone has to wait !!!
I was told it was a 1st world problem and of course the newer models were better !!!
I might check with the dealer after hearing this - anyone know what the TSB number is? 2005 D3 HSE 2011 D4 Landmark 2016 D4 HSE Lux
2017 Ford Tourneo VR46
Club Waitomo
21st Aug 2016 8:39 am
peteyd
Member Since: 08 Mar 2016
Location: South Bucks
Posts: 551
The original issue I reported, the car stuck in D or S, still happens now and then. It has been in to the dealer twice but as the issue isn't happening at that time and there are no fault codes, they can't find anything. Next step is to video the issue as it is happening.
Anyone else have a gearbox occasionally stuck in D or S?MY16 D4 Graphite in Loire Blue
15th Dec 2016 9:24 am
peteyd
Member Since: 08 Mar 2016
Location: South Bucks
Posts: 551
I've had this problem with the gearbox several times, so I took it back to the dealer's last week. They couldn't replicate the problem but did say that there was a software update available for exactly this problem. They have applied it and asked me to see if it happens again.
On getting home, I have looked at the outputs of the IID Tool as below for the TCM:
Does anyone have any info on the versions displayed and that there is another update seemingly available?
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
