cradgebank
Member Since: 09 Jul 2005
Location: Nottingham
Posts: 73
 
|
Hi Everyone,
Can anyone recommend where abouts I can pick up a "Speed Input'' wire on a TDV6 S.
I take delivery of my vehicle later this week and wish to transfer a Pioneer navigation system I have taken out of my old vehicle.
Thanks for any help.
Cradgebank
|
 10th Jul 2005 3:18 pm |
|
|
10forcash
Member Since: 09 Jun 2005
Location: Ubique
Posts: 16534
  
|
Errr,,
what sort of input? digital, analogue?
Have you asked Pioneer or LR tech 
It may be possible to take a supply from the speedo but I wouldn't do it - if you're intent on getting it to work, I would strongly suggest some form of opto - isolator so as not to present any spurious signals to the vehicle's data bus remember speed info is used by several systems, airbags, traction control & ABS are just a few of them!!
Cheers,
10forcash
|
| 10th Jul 2005 3:30 pm |
|
|
cradgebank
Member Since: 09 Jul 2005
Location: Nottingham
Posts: 73
|
There already must exist a "Speed input" signal that the Land Rover Navigation system uses.
My previous car was a RR TD6, all I had to do was take that input from the original Navigation loom, which I identified from my Rave CD, but not having any wiring diagrams for a Disco 3 I am lost.
Cradgebank
|
| 10th Jul 2005 5:25 pm |
|
|
Gareth
Site Moderator
Member Since: 07 Dec 2004
Location: Bramhall
Posts: 26701
|
I think once the Rave CD for D3 hits the streets a lot of questions may be answered.
|
| 10th Jul 2005 5:38 pm |
|
|
grommet
Member Since: 15 Feb 2005
Location: Northern California
Posts: 331
|
ABS module, pin 33 should be speed sense.
|
| 15th Jul 2005 4:23 pm |
|
|
cradgebank
Member Since: 09 Jul 2005
Location: Nottingham
Posts: 73
|
Thanks everyone,
I got hold of a LR Nav system wiring diagram and found the information I was looking for.
Cradgebank
|
| 15th Jul 2005 7:15 pm |
|
|
