Advertise on DISCO3.CO.UK
Forum · Gallery · Wiki · Shop · Sponsors
  Home · FAQ · New Posts · My Posts · PMs · Search · Members · Members Map · Groups · Profile · Donate · Register · Log In  
DISCO3.CO.UK > In Car Electronics (D3)

Radio issue
Post Reply  Down to end
Page 1 of 1
Stubear
 


Member Since: 05 Nov 2016
Location: Hertfordshire
Posts: 86

United Kingdom 2006 Discovery 3 TDV6 S Auto Bonatti GreyDiscovery 3
Radio issue

So drove to work today 88 miles about 2.5 hours in the car radio worked fine no issues on Aux with a iPod connected by 3.5mm jack . When I got to work i parked up and sat with the engine running for about 10 mins, then turned it off and did a bit of work on the laptop about 10 mins the rsdio was running on low power for that length of time. It then just switched itself off so I took the key out and got out.

Came back at end of day about 6 hours later turned it on pressed Aux put the iPod on and pressed play nothing, Checked the radio no sound, CD player no sound and won’t play and cd it selects the cd but doesn’t start playing.

Cd radio is about 14 months old as before I bought the car the dealer replaced it for a whole new unit as the original one stopped working. No idea if there is any warranty on it but will check with the dealer I suspect it will be a years worth

Now I put the Gap iid tool in and it came up with following error

B1A96-68
Bus still active after shutdown request algorithym based failure event information.
It’s a 2006 D3 S model

Any ideas I’ve tried shutting it down by turning off I know it’s not the pod as I’ve rebooted that and it works on another car.

Can an after market unit be fitted in place of this as I’ve heard conflicting views

Regards
Stu If it moves and it shouldn't duct tape it, if it doesn't move and it should walk away and get a big hammer  
Post #188412127th Nov 2017 6:28 pm
View user's profile Send private message View poster's gallery Reply with quote
Erea
 


Member Since: 19 Mar 2012
Location: Munster
Posts: 1509

Ireland 2006 Discovery 3 TDV6 Commercial Manual Zambezi SilverDiscovery 3

Try a hard reset and see if that helps.  
Post #188412327th Nov 2017 6:32 pm
View user's profile Send private message View poster's gallery Reply with quote
Stubear
 


Member Since: 05 Nov 2016
Location: Hertfordshire
Posts: 86

United Kingdom 2006 Discovery 3 TDV6 S Auto Bonatti GreyDiscovery 3

Sorry for being a bit dim but how do you do a hard reset, before I go and google it If it moves and it shouldn't duct tape it, if it doesn't move and it should walk away and get a big hammer  
Post #188412927th Nov 2017 6:46 pm
View user's profile Send private message View poster's gallery Reply with quote
Bodsy
Site Sponsor 


Member Since: 06 Nov 2006
Location: In the Clubhouse
Posts: 21361

United Kingdom 2007 Discovery 3 TDV6 HSE Auto Java BlackDiscovery 3

If you’ve got the IID tool, use service functions and vehicle reset will usually do almost the same.

Car started ok I assume? Bodsys Brake Bible

D4/D3 Remote FBH heat kits
BAS Remaps/ EGR Blank
Transmission Flush
Software updates/enabling

Clock/ SNOTM /3Flash / 4x4Info /BT Update /Service Reset/Error Codes / Gearbox Reset
See It Here  
Post #188419427th Nov 2017 8:44 pm
View user's profile Send private message View poster's gallery Send e-mail Reply with quote
Sea Raider
 


Member Since: 01 Nov 2016
Location: None
Posts: 4450

Stubear wrote:
Sorry for being a bit dim but how do you do a hard reset, before I go and google it


https://www.disco3.co.uk/wiki/Hard_Reset  
Post #188423527th Nov 2017 9:56 pm
View user's profile Send private message View poster's gallery Reply with quote
Stubear
 


Member Since: 05 Nov 2016
Location: Hertfordshire
Posts: 86

United Kingdom 2006 Discovery 3 TDV6 S Auto Bonatti GreyDiscovery 3

It started fine this morning radio back as normal no idea what happened there

Thanks

Stuart

Ps I read the hard reset seems a bit dodgy to me wires and battery terminals think I would be too frightened to try that for fear of frying something If it moves and it shouldn't duct tape it, if it doesn't move and it should walk away and get a big hammer  
Post #188462028th Nov 2017 9:41 pm
View user's profile Send private message View poster's gallery Reply with quote
Erea
 


Member Since: 19 Mar 2012
Location: Munster
Posts: 1509

Ireland 2006 Discovery 3 TDV6 Commercial Manual Zambezi SilverDiscovery 3

Good to hear it’s working Thumbs Up

RE. “Ps I read the hard reset seems a bit dodgy to me wires and battery terminals think I would be too frightened to try that for fear of frying something”

No, you disconnect the battery leads and then hold the disconnected leads together, so neither of the leads you are holding together have any power in them when you are doing it.  
Post #188464328th Nov 2017 10:37 pm
View user's profile Send private message View poster's gallery Reply with quote
Stubear
 


Member Since: 05 Nov 2016
Location: Hertfordshire
Posts: 86

United Kingdom 2006 Discovery 3 TDV6 S Auto Bonatti GreyDiscovery 3

Think it was the possible melted plastic that worried me If it moves and it shouldn't duct tape it, if it doesn't move and it should walk away and get a big hammer  
Post #188490229th Nov 2017 7:42 pm
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
< Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums
DISCO3.CO.UK is independent and not affiliated to Land Rover.
Switch to Mobile Site