wjpbill
Member Since: 06 Jan 2019
Location: Bucks
Posts: 18
|
As per my other posts, as soon as I turn my ignition on, I get the dreaded green mountain light flashing, brake light on etc. etc.
The second I turn on my ignition, not even the engine, I get "HDC Fault, Not Available."
I've just had a new battery and alternator fitted so I can discount them both.
I wanted to check Fuse 66 which is in the board behind the glove box drop down but whilst I can see it, I simply can't get anything past the bundle of cables to pull it out and test it.
Has anybody got any bright ideas on how you're meant to reach fuse 66? (Fuse 66 powers - (5A) Hill descent control (HDC) switch, steering position sensor, brake pedal position (BPP)switch, ESP master switch)
It's shown on here as nice and simple but after an hour and a half, I still can't get a pair of needle nose pliers in the space.
https://fusesdiagram.com/land-rover/fuses-...ery-3.html
Would, as ever, appreciate your help.
|
16th Jan 2019 6:16 pm |
|
|
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10608
|
under the glovebox is a panel with 2 philips screw heads.
Turn the 2 heads half a turn and drop panel down.
Disconnect footwell light (where fitted)
and remote panel.
Put your head on the mat and look and see if you can reach from below
|
16th Jan 2019 6:34 pm |
|
|
wjpbill
Member Since: 06 Jan 2019
Location: Bucks
Posts: 18
|
Thanks
Will give it go tomorrow morning when it's dry and light!
It really is in the most awkward place.
If I can't get at it from there, anyone else had this problem?
|
16th Jan 2019 6:35 pm |
|
|