eetamagog
Member Since: 20 Feb 2008
Location: Johannesburg
Posts: 17
  
|
Can anybody advise me how to remove the rear passenger door panel. The handle inside does not open the door only from the outside. It was not me that broke this as well it is another D3. I gather loosen all the screws I can see and give the panel a yank, and will the clips all break.  Discovery 3SE tdv6
|
 14th May 2008 4:21 pm |
|
|
tanters
Member Since: 24 Oct 2007
Location: Oireland
Posts: 4284
 
|
Well!
There are 6 screws to remove - recent experience!
The two at either end of the cup holder/ pocket - long screws so be patient
The other 4 are under the handle cover.
If you look under the handle you will see two little holes. Use a flat head screwbanner to prise it open at the end - dont pull off the top just yet!
When you have it open at the bottom - have a look in the gap and you will see two black clips up the top - they need to be pushed out to unclip the top of the handle. You can yank it off but you could damage the plastic underneath and it doesnt fit back properly 
Anyway, remove the 4 screws and once you have the 6 out, start at the bottom of the pannel and start pulling it out - there are about 10 yellow/ white clips that just need a tad bit of persuasion to come out and then it will all unhook at the top near the glass.
You can then reach in and unclip the different looms to remove the panel altogether.
If thats as clear as mud - come back to me 
|
| 14th May 2008 4:28 pm |
|
|
|
|
|
|
eetamagog
Member Since: 20 Feb 2008
Location: Johannesburg
Posts: 17
|
Thank You will try not break anything ??? Discovery 3SE tdv6
|
| 15th May 2008 12:08 pm |
|
|
