Member Since: 08 Sep 2014
Location: Denny
Posts: 30
Rear height sensor
After replacing all the rear wishbones my Disco 3 suspension started to go into into extended mode when not moving with rear left going up i checked the Hawkeye and the corner heights are all over the place
I changed the rear left sensor and replaces the plug complete with wires still the same readings.
Where should I check next, is there a junction box or could a wire be broken?
15th Feb 2020 5:41 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10360
You should check the voltage output of the sensor before blaming it or wiring.
It may require calibration
15th Feb 2020 5:57 pm
Sea Raider
Member Since: 01 Nov 2016
Location: None
Posts: 4450
I had a problem with one of my height sensors
Live values pointed out the problem very quickly
15th Feb 2020 6:03 pm
v8james
Member Since: 08 Sep 2014
Location: Denny
Posts: 30
Checked the voltages
Rr 2.08v, lr 1.95v, rf 2.17v, lf 2.17v
Left rear us a bit low but in the ball park, who would you reckomend around Falkirk/central Scotland to do the calibration
15th Feb 2020 6:57 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10360
You can do it with a gap iid
15th Feb 2020 7:30 pm
Sea Raider
Member Since: 01 Nov 2016
Location: None
Posts: 4450
Ive got a GAP but its locked to my motor, I can read and clear codes from other motors but unsure if I can calibrate.
I'm in Cumbernauld this weekend too
15th Feb 2020 7:38 pm
v8james
Member Since: 08 Sep 2014
Location: Denny
Posts: 30
Thanks for the offer, unfortunately I'm always today.
16th Feb 2020 12:34 pm
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10360
you need a licence for calibration ~£65
16th Feb 2020 1:23 pm
Sea Raider
Member Since: 01 Nov 2016
Location: None
Posts: 4450
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
