Member Since: 06 Jul 2018
Location: Essex
Posts: 332
Rear upper wishbones
Looks like I need to replace my rear upper wishbones
I don't like the look of that upper/inner Bolt removal.
Are there any tips for removal?
Or better still a good indy in the EN9 area?Disco 4 2012
30th Sep 2018 5:41 pm
Bardley
Member Since: 02 May 2018
Location: Hertfordshire
Posts: 440
If you look for Bennington, Stevenage, which is nearer the A10 at Ware than Stevenage...
Try Bennington 4x4.
I've had both inlet manifolds done by them and can wholeheartedly recommend them as an indy.
Clive is the owner, and Dan is also a top man.2011 MY D4 HSE
Previously 2001 D2 TD5, 1996 D1 300Tdi, 1985 90 2.2 petrol.
Bikes! KTM, BMW, British, Classics and others.
30th Sep 2018 6:24 pm
Browny90
Member Since: 19 Jul 2016
Location: Ashbourne
Posts: 687
I'm sure if you search on here you'll find plenty of info..
but.. the wisest move is to cut out the bolt with a reciprocating saw or similar. and replace with new with plenty of copper grease..
Can get new wishbones and bolt kits from Advanced Factors (site sponsor) with a 5% off search for the code too, currently ADVLRF, but is soon to change..
For simplicity I would buy new wishbones with the bushes fitted..
Also bare in mind, you have to disconnect the brake pipe to replace the wishbone so will have to bleed the brakes afterwards..
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum
