Triplezed3
Member Since: 29 Sep 2021
Location: Sydney
Posts: 3
|
Running air compressor hose from engine to cargo area |
|
Hi, I have installed an ARB air compressor in my Disco 3 (drivers side) engine bay for pumping tyres. Because hoses and tyre gauges are kept in the rear cargo area, I’d like to run an air line from engine to the rear cargo area and install a switch. This way, I will not need to open the bonnet when inflating the tyres. Has anyone done this before? Switch is easy enough but I’m not sure on best route from engine bay to rear cargo area for the air line. Any suggestions?
|
8th Nov 2021 8:06 pm |
|
|
KevinD3
Member Since: 05 Aug 2020
Location: Sutton Coldfield
Posts: 1193
|
When running a 100amp cable to the same place, I ran out of the engine bay down the side of the engine on the left side then followed he cable harness along the chassis frame, there are 3 grommeted entry holes at the bottom of the left “cubby hole” in the boot to come back in through. I rand 1inch flexible duct so should easily Nobel space for your air. 2008 HSE Stornoway Grey
My Wife thinks the D3 is a hobby, The D3 thinks the wife is 💕
|
8th Nov 2021 9:08 pm |
|
|