~Rich~
Member Since: 16 Mar 2009
Location: Sydney
Posts: 627
  
|
Thanks Gary, yes that is why I said FCR and LLAMS.
LLAMS actually has a built in Recovery mode which can be used if you have an ABS or Steering Angle fault:
4. RECOVERY (EXTRA HIGH) mode allows off-road height to be achieved when the suspension has lowered to the “safe†height of about access height. MEDIUM provides normal height and HIGH provides off-road height.
To enable, set the Llams height switch to HIGH then momentarily press the MODE button. The module LED will be red.
To disable, momentarily set the Llams height switch to LOW.
5. FADE-OUT mode can be used to limit additional height at extreme articulation in an attempt to overcome suspension faults that have occurred whilst using Llams MEDUIM or HIGH in conjunction with off-road height or when using RECOVERY mode whilst the suspension is not in safe mode. To enable, set the Llams height switch to MEDIUM then momentarily press the MODE button. The module LED will be orange.
FADE-OUT can be used with RECOVERY mode, either before or after RECOVERY mode is enabled. If RECOVERY mode is enabled after FADE-OUT then the module LED will be red, as the module LED indicates the most recent special mode enabled. To disable FADE-OUT, momentarily set the Llams height switch to LOW. Note that RECOVERY mode will be disabled at the same time if it had also been
enabled.
All this and additional height choices of -20, +30 & +50mm without even having to stop! 2005 TDV6 HSE Silver, LLAMS Height Controller, Tinted Glass, Onroad - 19" GG AT's, Offroad - 18" 275/65 MT, Traxside Dual Battery kit, Rasta Protection Plate, Alpine Roof, BAS Remap, ARB Air Compressor, eDiff  Custom Drawer and storage unit -http://www.box.com/s/jem0ilac3cner2mexq64 UHF CB, 4x4 Intellegence RWC, 120ltr Long range tank, Rock Sliders and Compressor protection plate Beanie grill, De Tango.
|
 5th Dec 2014 10:32 am |
|
|
