Smoedog
Member Since: 11 Dec 2020
Location: Travis Afb
Posts: 2
|
Suspension Failure...need ideas |
|
So I have a NAS LR3 and today I had my first real issue with it.
Left our campsite and got about 2 miles down the road and I got. Asuspension fault 30mph max message. I pulled over and got out and found I had dropped to the bumpstops and could hear the valve solenoid s cycling. But my pump wasn't running.
I limped home and scanned with my IID tool and it said my Right Front, and both rear sensors were out of range. Checked around and didn't see any damage or anything out of the norm. So I jacked up the truck a little bit and re scanned and the faults cleared and it raised back up. I have had the scanner hooked up and it shows no pressure drop or movement on any corner for 20 mins.
So my concern is what happened....did I valve get stuck and dump the system or what. I have to tow a camper 3 hours home in a couple days and don't want any issues.
|
8th Feb 2021 8:18 pm |
|
|
Globetrotter448
Member Since: 21 Mar 2017
Location: Londonderry NSW
Posts: 1783
|
You may have some dust from the filter medium in the compressor in the valves. Check the compressor filter. If its been off before you can do it in place.
|
11th Feb 2021 9:13 am |
|
|