Member Since: 28 Mar 2017
Location: Pretoria
Posts: 2
Blank infotainment screen
Hello All,
First post on this site, glad to have found a place to ask awkward Discovery related questions
I have a 2011 D4 HSE with what seems to be an intermittent screen fault. Screen goes on upon start up and between 2 and 20 minutes later goes blank. Audio keeps playing, and buttons can be pushed on screen (if you know where they are). Ran diagnostics and got a B108E error. Shutdown and restart just repeats the same problem. I tried a hard reset over the weekend with no change.
Any suggestions?
Owned a Defender 110 TD5 for 14 years and almost 500 000km so very much aware of LR foibles
Regards
24th Apr 2017 1:18 pm
dgardel
Member Since: 03 Nov 2009
Location: Greater Venice
Posts: 2025
B108E-13
Display - Circuit open
Cluster display connector fails continuity check, continuity circuit in display flex cable open circuit
Renew the instrument cluster. Refer to the warranty policy and procedures manual if a module is suspect
B108E-14
Display - Circuit short to ground or open circuit
Display circuit short circuit to ground or open circuit
Module internal fault
Renew the Front Entertainment Module. Refer to the warranty policy and procedures manual if a module is suspect
B108E-17
Display - circuit voltage above threshold
Display circuit voltage above threshold Module internal fault
Renew the Front Entertainment Module. Refer to the warranty policy and procedures manual if a module is suspect
B108E-1C
Display - circuit voltage out of range
Display circuit voltage out of range
Module internal fault
Renew the Front Entertainment Module. Refer to the warranty policy and procedures manual if a module is suspect
B108E-87
Display - missing message
Display internal video signal fault
Module internal fault
B108E-17
Display - Circuit voltage above threshold
Internal display circuit short circuit to ground, open circuit
Bus off
Front Entertainment Module (FEM) internal failure
Clear the DTC, switch off the ignition and allow sufficient time for the infotainment relay to power down. If the DTC persists contact Dealer Technical Support (DTS)
B108E-1C
Display - Circuit voltage out of range
Internal display circuit short circuit to ground, open circuit
Clear the DTC, switch off the ignition and allow sufficient time for the infotainment relay to power down. If the DTC persists contact Dealer Technical Support (DTS)
B108E-88
Display- missing message
Display - Bus off
Display communication failure
Clear the DTC and switch off the ignition. Allow sufficient time for the infotainment relay to power down and retest. If DTC persists reprogram the Front Entertainment Module (FEM)
Clear the DTC and switch off the ignition. Allow sufficient time for the infotainment relay to power down and retest. If DTC persists renew the Front Entertainment Module (FEM). Refer to the Warranty Policy and Procedures manual, or determine if any prior approval programme is in operation, prior to the installation of a new module/componentDiscovery 5 tdv6 HSE Corris Gray Outback Engineering Limited Edition
IID Pro MV License
24th Apr 2017 4:34 pm
Red110
Member Since: 28 Mar 2017
Location: Pretoria
Posts: 2
An update...
It turns out that the IPod cable seems to be the troublemaker. On a whim, I unplugged the Ipod cable and lo and behold the problem disappeared. 5 days now without the screen going blank whereas it used to be 5 or so minutes before it blanked out.
To make it more intriguing, I opened the connector on the cable which plugs into the car and the only fault I could see was that the cable earth shielding had disconnected from the plug. Fixed that and plugged it back in, no faults in three days.
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum