Advertise on DISCO3.CO.UK
Forum · Gallery · Wiki · Shop · Sponsors
DISCO3.CO.UK > Technical (D3)

Why did my car go into limp mode today (with codes)
Post Reply  Down to end
Page 1 of 1
mek
 


Member Since: 18 Mar 2015
Location: Zurich
Posts: 468

Switzerland 2006 Discovery 3 TDV6 Base 5 Seat Manual Tonga GreenDiscovery 3
Why did my car go into limp mode today (with codes)

Hi,

Whilst engine braking all the way down an Alp in France today my car went into limp mode. I turned off the ignition and restarted and it was fine. I had my IID with me and these are the codes but I can’t see why this might have happened. Can anyone interpret?

I think the faults at 138,794 km relate to fitting a new battery before the trip. Glad I did, glow plugs are knackered! I had to crank for 5 minutes on a stone cold car this morning.


Thanks!

Andy


VIN:
L319 - Discovery 3 2005
Vehicle scanned on 10-02-2018 18:34
Using IIDTool BT V3.0 B2481

Audio System

B1A00-16 (28) Control module - General electrical failure - circuit voltage below threshold
( at 139246 km )
B1D21-13 (2F) Remote control switch - General electrical failure - circuit open
( at 138794 km )
B1A02-01 (28) Speaker 2 circuit - General failure information - general electrical failure
( at 138794 km )
Body Control

B1B02-28 (2F) Low frequency coil - General signal failure - signal bias level is out of range/zero adjustment failure
( at 138790 km )
B1C57-14 (6C) Passive start ignition relay coil circuit - General electrical failure - circuit short to ground or open
( at 138790 km )
B1D14-15 (6C) Interior lamps 2 circuit - General electrical failure - circuit short to battery or open
( at 138790 km )
B1D17-87 (2F) Bus circuit - Bus signal/message failure - missing a message
( at 138790 km )
U0155-87 (28) Lost communication with instrument cluster control module - Bus signal/message failure - missing a message
( at 138790 km )
Engine TDV6

P0181-00 (6C) Fuel temperature sensor A - circuit range/performance
Instrument Pack

U0102-87 (28) Lost communication with transfer case control module - Bus signal/message failure - missing a message
Ventilation

B1B78-84 (28) System pressure - Bus signal/message failure - signal is below allowable range
( at 139248 km )
  
Post #191322310th Feb 2018 6:59 pm
View user's profile Send private message View poster's gallery Reply with quote
Pete K
 


Member Since: 15 Jan 2016
Location: GL
Posts: 10368

England 2005 Discovery 3 TDV6 HSE Auto Rimini RedDiscovery 3

Fuel temp sensor ?

That's in the leak off pipes in the middle I think
  
Post #191323110th Feb 2018 7:33 pm
View user's profile Send private message View poster's gallery Post Reply
Display posts from the last:  
Post Reply Back to top
Page 1 of 1
Jump to:  
Previous Topic | Next Topic >


Posting Rules
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum



DISCO3.CO.UK Copyright © 2004-2024 Futuranet Ltd & Martin Lewis
DISCO3.CO.UK RSS Feed - All Forums

DISCO3.CO.UK is independent and not affiliated to Land Rover.
Switch to Mobile Site