countrywide wrote:

discocuzzy wrote:

Were on there when i got it Andy, standard fit on the HSE i think?

I am but a poor 'S' driver

I will have to look at a retro fit when I start fitting some toys to it. If you removed your RAI does it leave a load of holes behind ?. Just thinking about it and what would happen if I sold it.

I just finished retro-fitting parking sensors to the front of mine. I got a 4 sensor system off ebay http://cgi.ebay.co.uk/ws/eBayISAPI.dll?Vie...amp;ih=021
and the sensors fit perfectly into the bezels that you can buy from Land Rover dealers (I got mine from Nick - about 20 quid for 4 IIRC). The rear of the bumper plastic is marked with the cut outs for the bezels, so you just need a dremmel or something similar to make the holes the right size and shape. As luck would have it, even the sensor on the nearside corner has a long enough wire to route up into the 2nd battery box (drivers side - UK spec) so you can put the electronics box in there, then just run a cable into the vehicle for the buzzer and switch. Of course this is for vehicles with no rear LR fitted parking sensors. If you already have that then I think you can plug genuine sensors into the exisiting system, but with getting it enabled by the stealer and the cost of the LR's sensors it's probably an expensive option. I'll post some pics if anyone's interested.

 D3 TDV6 S 2005 - TorqTune, Privacy Glass, Remote FBH, 19" HSE Alloys, Boot liner, retrofit F&R PDC
Defender 90 Truck Cab TD5 2003 - Ifor Williams back, alloys (SWMBO's toy - well, one of them )
Toyota Yaris 2008 (SWMBO's company shopping trolley)