Member Since: 22 Sep 2010
Location: Notts.
Posts: 8115
Extended height only!
OK got your attention , I've had this fault for a while but now need to fix it for safety reasons, when I select access height the car lowers ok and then the rear goes into extended height, I didn't have this fault until I adjusted the height with the Iid, all corners are set at correct normal height.It can when others can't,
It will when others won't,
It goes where others don't.
22nd Mar 2017 8:47 am
geoff.
Member Since: 24 Jan 2010
Location: West kent
Posts: 8531
i would check your height sensors
22nd Mar 2017 9:28 am
pjm-84
Member Since: 04 Oct 2016
Location: Hampshire
Posts: 2444
Had the same problem.
Front height sensor was sticking. Also just cleaned the mounts on the rear height sensors as this was not allowing the rods to rotate freely.
OK got your attention , I've had this fault for a while but now need to fix it for safety reasons, when I select access height the car lowers ok and then the rear goes into extended height, I didn't have this fault until I adjusted the height with the Iid, all corners are set at correct normal height.
I had exactly the same problem after doing the same as you, in the end I used the new calibration method on the IId and re set all corners to the correct heights and all has been well now.Range Rover Westminster 4.4 TDV8 what a car
Discovery 3 HSE 2006 gone but never forgotten
Member of the 234,567 mile club😎
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum