Forum · Gallery · Wiki · Shop · Sponsors


Home > Member Galleries > bbyer > NAS Trailer Socket Pin ID and Wire Colours

Tekonsha Ford Brake Controller Adapter part number 3035-P
This is the adapter cable between the Brake Controller and the existing C2590 female plug located near the brake pedal on NAS spec LR3's. The flat 4 pin plug of the adapter cable connects to the Controller; the rectangular 6 hole male plug to C2590.

There are only four conductors in the adapter cable, but one will see five pins within the Land Rover C2590 plug. The #2 pin is not required for the NAS setup. #2 pin is the circuit between the head lamp switch and vehicle side running lamps required in the civilized world.

The single pin at the bottom in the picture is #3 and on the Land Rover, a Black wire tied to ground. The other pin at the bottom and across to the left is #6, and Blue on the Land Rover. This is the Brake Controller output to the trailer socket at the rear.

#4 is the pin at the top left, and is a White coloured wire from the battery. Pin #5 is from the stop light switch, and is Green on the Land Rover.

Note that the adapter cable colours do not necessarily follow all the above referenced Land Rover colours.
Rate this file (No vote yet)
Rubbish
Poor
Fair
Good
Excellent
Great

File information

Filename
Tekonsha Ford Brake Controller Adapter part number 3035-P.jpg
File Size
60 KB
Dimensions
300 x 218 pixels
Displayed
246 times
BBCode
BBCode Full Size