Search results - "UHF" |
Radio location537 viewsMy remote head UHF CB mounted on the front of the ashtray, ham HF/VHF/UHF remote head radio mounted on a block in the coin tray and my GPS on a turned wooden block in the cup holder. Both radios are under tha driver and passenger seat and the antenna for the GPS is suction mounted inside the windscreen.
|
|
UHF CB374 viewsGME TX3400 UHF CB remote head mounted on the front of the ashtray.
A piece of wood was turned to fit the cup holder to mount the GPS
|
|
UHF CB438 viewsThe remote head of the GME TX3400 was mounted on the front of the ashtray after unclipping the ashtray facia. The head is very light, double sided tape was used plus 1 screw to hold it.
|
|
Antenna Mount445 viewsA light dual band VHF/UHF antenna mounted on an 3mm x 25 alloy bracket
|
|
Antenna Bracket388 viewsThis was bent from a piece of 3mm x 25mm alloy flat bar. I used automotive grade double sided tape and two screws to fasten it. I have a dual band VHF/UHF antenna on this bracket
|
|
UHF Antenna80 views
|
|
Information and Comms167 viewsUHF, Streetpilot, Mobile and iPod
|
|
102 views
|
|
186 views
|
|
UHF Radio484 viewsGME TX3400 head mounted in console
|
|
UHF Radio installed20 views
|
|
UHF Radio head21 views
|
|
Aerials 0298 viewsRoof mounted fixed and temporary aerials
|
|
Aerials 01101 viewsRoof mounted fixed and temporary aerials
|
|
UHF radio beside drivers seat167 views
|
|
UHF radio and handset149 views
|
|
HF handset, ASUS umpc, UHF handset164 views
|
|
UHF antenna mounted to bracket fixed to driving light mount171 views
|
|
UHF antenna200 views
|
|
Bararranna Gorge Gammon Ranges Sept 2007162 viewsOpposite lock Rear Wheel Carrier and UHF antenna
|
|
UHF Antenna Mount360 viewsView of both antennas (UHF & Mobile Phone)
|
|
UHF Antenna Mount384 viewsView from underside of bonnet. The lower half of the mount is folded from stainless steel and bolted through an exisitng oval shaped hole in the bonnet. This hole is throught the heavy steel plate that the bonnet hinges bolt to - not just the aluminium panel. A specially machined rectangular nut was made to pass through the oval hole, rotate 90 degrees and then stopped from turning by a slight shoulder on the nut.
|
|
UHF Antenna Mount321 viewsWith Bonnet open. Note antenna finishes parallel with windscreen when bonnet is open
|
|
Mobile Phone antenna mount342 viewsView of mount with bonnet open - note stick on patch to protect plastic panel at base of windscreen
|
|
View from the front88 views
|
|
Handpiece Bracket97 viewsPiece of aluminium strip.
|
|
UHF Head Installation103 viewsThe unit is made from 16 mm craftboard. Screwed and glued together. A tight fit. A little silastic to help keep it in position.
|
|
Side View126 views
|
|
Top View109 views
|
|
View from underneath96 views
|
|
33 views
|
|
UHF - install18 views
|
|
UHF - install17 views
|
|
UHF - tape17 views
|
|
Thread upload7 viewsImage uploaded in new thread
|
|
|
|