| Search results - "ready" |
heated seat (base) wiring410 viewsThe Small connector takes the plug from the seat back pad, the larger connector (with red) is fitted into the multiplug casing uder the seat - the male side of this is already pre-wired.
|
|
370 views
|
|
109 viewsFinished adapter ready to be locked in
|
|
ready to go out105 views
|
|
Ready for the off at Tixover61 views
|
|
214 viewsReady for installation
|
|
Loaded and ready for the gravel at Paynes Find259 views
|
|
Sliding floor22 viewsReady for action....
|
|
84 viewsTool kit ready..............
|
|
219 viewsTool Kit ready..............
|
|
147 viewsThe real tool kit ready
|
|
10256 viewsSet up all the controller components in the boot in the unused space available there. The V1000 is ready to be hooked up.
|
|
Jacked-up, loosened bolts, ready to replace.441 views
|
|
13-20200928_Vigor166_Web_DSL_Stats_Ready6 views
|
|
Ready for off at Yarwell71 views
|
|
Ready to winch a friends disco 4 194 viewsback of the picture you can just see another freinds (luvbus) disco 3 acting as balast to stop the disco 4 pulling me down hill
|
|
Stripped down ready to start1011 views
|
|
108 viewsTest fitting the screen. The bottom edge of the rear cover of the screen has been already dremeled off in this pic, notable as the circuit board can be seen.
|
|
79 viewsCarPC closed and ready for mounting. Note the modification to the rear of the case to allow extra USB sockets attached to the motherboard pins.
|
|
tanks a ready19 views
|
|
Locking Kit626 viewsready to install
Mfd from https://www.facebook.com/DifferentialPartsUS
|
|
![22072008048 [640x480].jpg](albums/userpics/12862/thumb_22072008048%20%5B640x480%5D.jpg "Filename=22072008048 [640x480].jpg
Filesize=62KB
Dimensions=640x480
Date added=24.Jul 2008")
D3 and caravan ready to go151 viewsLatest fuel saving measure when towing :)
|
|
3 Radio etc removed ready to remove dash pocket85 views
|
|
Ready to go11 views
|
|
G4 Ready78 views
|
|
Thread upload36 viewsImage uploaded in thread 102519
|
|
Ready to go!69 views
|
|
H4h 4x4 European Rally.11 viewsGetting ready for the rally...
|
|
05270 viewsGetting all the wires ready to hack.
|
|
Ready for the off at Tixover 269 views
|
|
07254 viewsThe factory amp is all hacked and ready to go.
|
|
Studded AT2\'s. 5 new waiting in garage, and one additional spare already used two seasons.50 views
|
|
This definitely needs investigating.....171 viewsI had already picked this BOAT out on the O/S map but now I\'ve seen it in the flesh, it needs to be investigated
|
|
Boots on ready for Rockingham87 views
|
|
Box Closed with 7 Blade NAS connectors577 viewsBox closed up and ready for use. The box and cable connectors are reasonably weather tight and hence can be submerged for a bit while doing a creek crossing but as with the 3, do not use the creek bed as a parking stall. Similarly, the connector recessed into the bumper will probably remain somewhat dry as long as you keep moving but if you get stopped, well that is another story.
As such, I put a vial of desiccant in the metal box prior to closing it up to reduce corrosion due to moisture build up.
|
|
![BtuCwV7CMAE4YAZ[1].jpg](albums/userpics/14719/thumb_BtuCwV7CMAE4YAZ%5B1%5D.jpg "Filename=BtuCwV7CMAE4YAZ[1].jpg
Filesize=37KB
Dimensions=600x399
Date added=29.Jul 2014")
#readytodiscover24 views
|
|
Bumper Off132 viewsReady to cut holes
|
|
Tidied & ready to go56 views
|
|
D3 Side Step Repairs164 viewsFinished job all I need to do now is wash it all off. I had already replaced the front door trim using new trim fixers and as you can see it was still dirty.
|
|
D3 + 18 foot Bushtracker - Ready to travel!147 views
|
|
Mom\'s first day in her discoveryII - I miss it already205 views
|
|
Ready to refit the cover38 views
|
|
Seat base finished and ready to fit39 views
|
|
D4 hid installed in light ready to go213 views
|
|
273 viewsgot the front all off ready t put the new bumper
|
|
Disco3 and camper setup ready to go157 viewsFirst family road trip - total 3500km
Adelaide, Mildura, Swan Hill, Echuca, Wodonga, Beachworth,
Bright, Falls Creek, Mansfield, Mt. Buller, Craigs Hut, Halls Gap & the Grampians.
|
|
ready for new owner126 views
|
|
ready for new owner124 views
|
|
New Speaker Cables.107 viewsThis is the door connector, Main loom to Right, Door side to the left. to the top of the connectors you can see green and Green white wires which are the speaker ones. The door wiring is premium and has two pairs, the main loom was a 1 pair high line, so i am adding the pair you see (one already pinned up) to upgrade the loom to premium.
|
|
defender 90 and disco 3 getting ready75 views
|
|
Ready to Roll114 viewsCompleted putting on sliders, mud tyres etc ready for Kauri Coast 2013.
youtube.com search snafu4wd
|
|
Stripped and ready62 views
|
|
Temporary connections for testing - loom ready64 views
|
|
237 viewsLining up the D3 for our first run. Mud/ruts, DSC off, HDC off, Jimi Hendrix on the stereo ... yup, ready to go!
|
|
250 viewsWe did it!! Winner of the first Northam Mud Drags. Now to get ready for next month\'s comp ...
|
|
The Disco ready for scruteneering241 viewsNew recovery points fitted, ground clearance 355mm
|
|
ready for the off152 views
|
|
maxxraxx fastened on.... ready to load444 views
|
|
Fitting towbar electrics445 viewsFitting towbar electrics - connectors already in use!!!
|
|
fits on exsisting holes that are already there,realy easy to fit182 views
|
|
157 viewsPattern for the right side slider. Almost ready to cut!
|
|
gas stove slides out under fridge107 viewsvery useful mod - youdon\'t have to unpack anythinig to be ready to cook. the stove gas is piped from the rear of the trailer, ie. the standard gas cylinder. pipe goes thru grommets along bodywork, and uder the fridge. works a treat. the door adds shielding in high winds if need be
|
|
Back section with size 20 biscuits ready to received front section of floor140 views
|
|
145 viewsbuilt painted and ready for monitor (NEXT BASE)
|
|
Completed unit126 viewsReady for frame
|
|
Wedding ready!5 views
|
|
TS ready 114 views
|
|
TS ready 215 views
|
|
At home18 viewsJust had a nice clean ready for towing the caravan on holiday
|
|
Pallet ready15 views
|
|
1867 viewsWinch control pack mounted, ready to wire now.
|
|
1406 viewsThe PC with the lid on, Ready for the Car.
|
|
Ground anchor assembled ready for use.296 views
|
|
Badged up and ready to rumble61 views
|
|
Ready for work88 views
|
|
Ready for work91 views
|
|
A pillar template in place - ready to drill (through extremely hard metal!)167 views
|
|
433 viewsA glimpse of the final installation, with a working map-reading light. In case the GPS doesn't work ;p
This is an old picture as the touchscreen is removed already.
However, I kept the reading light.
|
|
416 viewsUp and ready to go
|
|
Hub all nice and cleaned ready for new disc16 views
|
|
Getting ready to go over the wall25 views
|
|
Ta da! READY!54 views
|
|
FBH pins19 viewsFBH pin 2 in use already...
|
|
Excellent condition HSE wheel set ready to go for summer 60 views
|
|
Ready to leave for Spain106 views
|
|
Loaded & ready to roll...92 views
|
|
Windscreen Blind169 viewsThe windscreen is particularly hard to come up with an accurate shaped template to make a proper made to measure blind. I gave up.
Here is a make shift arrangement on the inside but I discovered it did little to reflect the heat as once the heat came through the glass it was already inside the car. Doh! Stretching it across the outside of the screen had a much better effect.
|
|
Kens\' motor - getting ready for Morocco200 views
|
|
All the components assembled ready for wiring.829 viewsThe 5watt resistors get fairly hot, be careful not to have them touching the relay case or use a larger box for yours.
|
|
First outing30 views
|
|
View of mounted panel from front left side872 viewsNote that all valve handles are shown in the OFF position, (the trouble position). In this case, the air that is in the air springs, (if any), is trapped in there - that is the valve blocks cannot vent whatever air is already in the air springs as the air lines between the springs and respective valve blocks are closed off by the FASKIT valves. In operation, there may be only trouble with one air spring, (perhaps a wheel height sensor), and as such, only one valve would need to be closed. If there was complete air compressor failure, then all valves would be closed and then as required, each spring could be manually filled from an outside clean dry oil free air source.
|
|
Flexible wire rope fishing leader 0.032" diameter exiting carpet 1932 viewsThis is all you see of the completed mod.
The short little angled "line" about an inch long that looks like a piece of debris and is located a few inches "above" the support cable is actually the wire rope release cable exiting from under the carpeted lift gate cover.
I drilled a very small hole in the carpet and pushed the 0.032" diameter release wire thru and then slipped the loose end under the black plastic.
To release with the lift gate etc closed, from the inside, just pull the loose end free from under the black plastic and gently pull wire about 5mm, (1/4"), and the upper door catch should release. You will have to manually push the upper door out wards to actually effect opening, but you will already be inside the rear cargo area so that part is easy to do.
The assumption is that the lower door latch still works electrically and hence, the lower lift gate half will open as normal by pressing the usual button on the top left of the lower door half.
|
|
My first expedition and already an expert.110 views
|
|
LR 6HP26 transmission oil part number TYK5000501413 viewsThis jpg shows the genuine Land Rover transmission oil, part number TYK500050, for the 6HP26X tranny. The Shell product number is M-1375.4 but you cannot buy the oil retail from Shell. The container size is one litre.
A routine oil change where the pan/filter combo is not changed takes about 3.5 to 4 litres of oil. When the tranny is brand new, a dry fill can take up to 9.5 litres of oil however around 7 litres is more common for when a new pan/filter combo is installed on an already in service transmission.
|
|
ready to go42 views
|
|
the sign says are you ready61 views
|
|
MT/Rs Fitted Ready For Kielder.338 views
|
|
92 views
|
|
Open and ready to Play............ Yeah !!!!167 views
|
|
Discovery SE - ready for delivery227 viewsThe day I visited the dealer, this car was awaiting delivery.
|
|
Ready to go!!170 views
|
|
Ready for delivery143 views
|
|
Ifor and Zafira ready to roll31 views
|
|
Ready for the off172 views
|
|
Ready for Nurburgring131 viewsDizzy ready to tow the Caterham to the Nurburgring
|
|
Ready to tow149 viewsThe car behind, if you can see it is a SORN Rover 214 SEi, Cost me £20 and died on me!
|
|
193 viewsNearly Done, ready for fitting
|
|
Ready for action?61 views
|
|
Ready and waiting54 views
|
|
90 views
|
|
Ready for the off!168 views
|
|
136 views
|
|
Ready To Play301 viewsWho says you can\'t get 2 kayaks and a canadian on a roof rack?
|
|
Thread upload6 viewsImage uploaded in thread 149134
|
|
Outside house ready to leave for Brittany 1 car 2 adults 3 kids 1 boat 5 bikes214 views
|
|
Traffic Jam at Roych227 viewsGroup 1 set off half an hour after Group 2 and yet still arrived at the Roych before Group 2, who arrived just as Group 1 were sizing up the obstacle - thus causing a traffic jam of 7 D3\'s (Gareth has already gone down). Some lame excuse about HAVING to go to the pub because they had no packed lunch... yeah right!
|
|
Netgear Readynas Duo31 views
|
|
readynas duo straped in29 views
|
|
Shoes Off ready for a week in the garage98 views
|
|
new car getting cleaned ready for me20 views
|
|
Ready steady...126 views
|
|
Necessary Approval143 viewsGetting ready to take off with my new motor, SWBO approves
|
|
Wire swapping88 viewsPulling out the old cut wires while routing in the new, you can see some already done in the lower loom body. The loom will be re wrapped at the end so i only need to hold it in place periodically at this point.
|
|
D2 pwned by LR3 :D261 viewsTransmission in D2 went out so I kindly towed my poor friend over hill & val (literally!) to safety. Just got the tow strap attached in this pic & ready to roll. What fun!!
|
|
Camel Trophy 1996 Kalermantan 18 viewsAll the vehicles assembled at hotel ready for there crews, shiny and new
|
|
Overlaid wires93 viewsOverlaid wires draped to floor ready to be inserted into loom.
|
|
Ready to tackle the rest of Pindale202 views
|
|
|
|
|
