No mate, should be 12v so no problem,
Well I’m still here to tell the tale
Andy05 TDV6,"S" in all colourcoded Zermatt silver,7 seats winter pack HK 6cd stereo,Dual climate,Xenons,
Re-Con Engine,De-Tango,Reverse camera,Fog/DRl lights,Aux Battery, perm Aux socket in boot,LED Volt meters in roof panel,Built in tom tom, Strobes fitted in grille, Aux switches for trailer lights fitted in roof panel,Roof Rails,Grille conversion
25th Feb 2019 2:31 pm
Member Since: 27 Sep 2013
Anyone know how I remove this top get to the wires thanks?
25th Feb 2019 3:31 pm
Member Since: 13 Jul 2016
You need to remove the plastic trim that goes along the base of the seat.
When you’ve undone the clips underneath, move the seat all the way forward and raise it up.
I have done the splice , have 12.4v going to the RF unit in the roof and 11.4v on the blue wire but still no joy. Do I have a duff unit does anyone know please ? Both fobs don’t work and I’ve had no previous problems with them.NU14 D4 HSE Luxor
D2 ex police upgraded to HSE
27th Feb 2019 6:11 pm
Member Since: 08 May 2016
Location: London & Carmarthenshire
Big thanks to Greedy and others on this thread
I don't have a sunroof but went wading a few times on a weekend of green laning. Then the remote stopped working though central locking ok inside car. Quick check on RRSport and I was pointed at this thread. Just got round to doing it but a seriously easy fix. Worst part is the trim.
Seat forward and up, remove the b pillar trim panel, then the trim over the sill front and rear.
Pull off trim piece front corner of seat, then unscrew side at rear, before removing side piece.
Pull off trim by bonnet release and also piece by C pillar (optional but probably easier)
Ease up the 3 white fasteners with a screwdriver then pull up the panel covering the wiring and pull back.
Do the fix
Replace in reverse.
I found that someone previously had dropped the clips for the sill trim under the wiring and just glued the trim to the panel! Clips were still there but rusty, along with a random bolt also very rusty. Its now well soldered, shrink wrapped and on top of the rest of the wiring, so hopefully the next time I go wading, it'll be OK!
Thanks again guys for this fix and advice.
13th Jul 2019 12:52 pm
Member Since: 28 Dec 2019
6 years down the line and this thread is still golden!
I had the dreaded sunroof leak, then the car stopped locking so came across this hour later car now locks!
6th Jan 2020 4:22 pm
Member Since: 09 Mar 2015
Ditto! No doubt this thread has saved me a small fortune.
Note that there is no need to remove A and C pillar trims in order to access the loom. (Photo shows A pillar trim still in situ).
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum