jsamuelson
Member Since: 07 Feb 2011
Location: Cornwall
Posts: 214
|
Hey gang, I’m getting a P2459 error in conjunction with a dash DPF Full message. I have blasted down the motorway twice, nothing cleared. The car feels ok, none of that slight rumble and sluggishness you do get when the DPF is actually full.
I’m going to go for another run today but I’m thinking maybe it’s a sensor issue?
Any clues appreciated.
|
6th Dec 2018 11:30 am |
|
|
Sidestick
Member Since: 22 Apr 2012
Location: Rome
Posts: 2288
|
Common in Italy after intense use in town,
on mine i have had to remove the DPF from the exhaust (just few bolts) and wash it using a special dpf cleaner (10 lt. tank and not so cheap) filling it and waiting until it starts to flow out from bottom (require some minutes).
After cleaning it was like new looking inside.
Then after refitting you need to go in "service" on the iidtool and "say" to the car that a new dpf has been installed (this will reset the sensors on the inlet and outlet the dpf) and is mandatory in order to clear the message on the dash.
I have run 4 years before another "dpf full" advisory on the dash - Easy-Lift suspension module 4.0
- GoodWinch 9500 lb
- Full underbody protections
- Tree/Rock sidebars
- Prospeed roofrack & ladder
- Compressor guard
- Raised Air Intake
- Driving lights (2+4)
- 50 mm Waffle boards
- Altox Heater control
- Overland Rooftop Tent
- Rear seats entertainment
- Front & Rear camera
- GVIF
- Removable tow bar
- Cubby box fridge
- BFG KO2 265/65R17
- iidTool BT
|
6th Dec 2018 5:37 pm |
|
|