82ndTOP
Member Since: 09 Jan 2017
Location: Brighton
Posts: 14
|
rear upper tail gate trim 2 |
|
So, ongoing from my post about the trim on the upper tail gate and fitting strobe lights,
I intend to run the wires from the strobes through the flexi grommet thing that holds the upper brake light wires.. is there space ? and then into the rear corner pillar
now the question is this,
which route is the easiest, take the loom across to the A pillar via behind the roof lining or down the rear post and then along the floor under the carpets ?
how are the carpets held in place ? clips ?
many thanks
I look forward to your replies
|
16th Jan 2021 1:47 pm |
|
|
Pete K
Member Since: 15 Jan 2016
Location: GL
Posts: 10360
|
there should be room in the grommets
probably slightly easier to go along the bottom
depnds where your switch is going
|
16th Jan 2021 3:29 pm |
|
|
82ndTOP
Member Since: 09 Jan 2017
Location: Brighton
Posts: 14
|
Thanks for that Pete,
The switch will go below the switch i have fitted for the front strobes, this is on the small section to the right of the steering wheel.
the control unit will join the other one in the spare battery box under the bonnet,
will take some photos and try to work out how to upload tehm on here.
|
16th Jan 2021 4:21 pm |
|
|
Globetrotter448
Member Since: 21 Mar 2017
Location: Londonderry NSW
Posts: 1782
|
My reversing light cables went through the grommet okay, then down the RH side rear trim and along the sills to the front and then up into the dash.
|
17th Jan 2021 8:54 am |
|
|