| Last additions - anthill's Gallery |
Headlight Protector382 views10 Nov 2005
|
|
Headlight Protector Top Fixing379 views10 Nov 2005
|
|
Headlight Protector336 views10 Nov 2005
|
|
Aussie Spec Rear Mudflap366 views10 Nov 2005
|
|
Aussie Spec Rear Mudflap315 views10 Nov 2005
|
|
Getting Warmer524 viewsHeading North out of the cold! Mrs anthill and Oliver13 Sep 2005
|
|
Toy Disco481 views270 tonne payload Haulpack dwarves the Disco. Newman Western Australia13 Sep 2005
|
|
Wild Flowers343 viewsWreath Flowers13 Sep 2005
|
|
Caravan connection413 views13 Sep 2005
|
|
Mount Nameless - Tom Price360 viewsHighest 4WD access in Western Australia13 Sep 2005
|
|
Radio location537 viewsMy remote head UHF CB mounted on the front of the ashtray, ham HF/VHF/UHF remote head radio mounted on a block in the coin tray and my GPS on a turned wooden block in the cup holder. Both radios are under tha driver and passenger seat and the antenna for the GPS is suction mounted inside the windscreen.22 Jul 2005
|
|
Antenna Mount460 viewsBracket mounted using existing holes behind the grill. The design of this bracket is listed elsewhere.22 Jul 2005
|
|
Antenna Mount445 viewsA light dual band VHF/UHF antenna mounted on an 3mm x 25 alloy bracket22 Jul 2005
|
|
Antenna mount454 viewsBrackets fastened behind the grill using existing holes22 Jul 2005
|
|
Ham Radio452 viewsThe remote head of the Icom IC706 mounted on a block of wood shaped to fit the coin holder. This is an HF, VHF and UHV transceiver.22 Jul 2005
|
|
Ham Radio446 viewsThe remote head of an Icom IC706 was mounted on a piece of wood shaped to fit into the coin holder. This is quite a tight fit and does not shake loose. The radio is mounted under the driver seat.22 Jul 2005
|
|
UHF CB374 viewsGME TX3400 UHF CB remote head mounted on the front of the ashtray.
A piece of wood was turned to fit the cup holder to mount the GPS22 Jul 2005
|
|
UHF CB438 viewsThe remote head of the GME TX3400 was mounted on the front of the ashtray after unclipping the ashtray facia. The head is very light, double sided tape was used plus 1 screw to hold it.22 Jul 2005
|
|
Antenna Bracket388 viewsThis was bent from a piece of 3mm x 25mm alloy flat bar. I used automotive grade double sided tape and two screws to fasten it. I have a dual band VHF/UHF antenna on this bracket22 Jul 2005
|
|
|
|
|
