Search results - "grip" |
199 viewsDidn´t loose contact, but grip was zero.
|
|
241 viewsThis Toureg is stuck - doesn´t look like it. After 8 hours of driving everyone agreed that with the big 10cyl. diesel engine you should probably oder the rear difflock as well... In this picture the rear left anf front right wheels have no grip, esp or whatever just doesn´t do it.
|
|
116 views
|
|
Almost a roll, but not quite...55 viewsI\'d \'launched\' myself at a 6ft hill and got to the top- but at an angle- the offside rear gripped and pulled us around to the right- perilously close to the edge... time for spare undies I think...
|
|
63 viewsCut a slot in the socket grip to fit the cutout
|
|
grip11 viewsnew wheel
|
|
Thread upload12 viewsImage uploaded in new thread
|
|
Gripper, wags his tail so much he\'s nearly wagged it off!!160 views
|
|
Yup, Im Stuck492 viewsIt does not look too bad, but the front pass wheel is in the ditch (no contact) the other fron wheel is on mud, the pass rear weel is in an \'ice pack\' and the other rear wheel is at full extension and not gripping.....
|
|
Missing grip seat front - left22 views
|
|
2 views
|
|
2 views
|
|
1 views
|
|
1 views
|
|
1 views
|
|
7 views
|
|
Thread upload10 viewsImage uploaded in new thread
|
|
81 viewsNowhere closer to get a grip
|
|
Thread upload1 viewsImage uploaded in thread 191555
|
|
Sweden winter 07 - Goodyear Ultra Grip 500212 views
|
|
Sweden winter 07 - Goodyear Ultra Grip 500212 views
|
|
looking on to see if i get stuck..suzuki just pulled landy out28 viewsbargrips arn't all that good really. thats my excuse and I'm sticking to it. but managed to get some fun places
|
|
8 views
|
|
7 views
|
|
2 views
|
|
1 views
|
|
8 views
|
|
7 views
|
|
Pattern for Expo Roof Rack Floor Sheet397 viewsI used a 3mm sheet of Aluminium - with 150mm wide Grip Tape to do the Chevron Patter to make it a bit safer. Note the sheet is 1610mm long, 1100mm wide at the front and 1060mm wide at the back. I drilled 3 rows of 5x 12mm holes - one row down the centre and one either side 30mm in from the edge. The hole centres being at 31mm from the front edge, next 420mm from 1st hole centre, the 375mm from 2nd hole, 372mm from 3rd hole, 375mm from 4th hole, leave 31mm to the back edge. Edited May 2008: I've subsequently cut the sheet in half lengthways to make removal and fitting easier as I found the sheet increasing noise and reduces MPG considerably.
|
|
Thread upload5 viewsImage uploaded in thread 179591
|
|
|
|
|