clubcars
Member Since: 03 Jul 2014
Location: Kent
Posts: 14
|
Lots of good advice for fitting FL2 screens to Discovery 3, however I want to know how to remove the FL2 screens from the headrests they are supplied with for a custom install. The screens are in very tight and I don't want to start pulling and pushing without understanding the fittings behind
|
21st Jan 2016 11:23 am |
|
|
Russell
Member Since: 24 Aug 2007
Location: Kent
Posts: 10564
|
If you read the post I posted the link to you will find out how to remove the screens.
- Pull little black cover / plug out of bottom of headrest.
- In the hole you will feel a metal lollipop stick (for want of a better description)
- it has a small hole in it, i just put a small screwdriver through the hole & pulled it out (about 5 ins long)
This lock the screen into the holder...once this is hout the screen is just held by 2 tabs eack side...
Again using a small screwdriver, down the side of the screen (opposite from wire exit) open the gap between screen & holder. You should be able to see the 2 tabs Then with small diver lever screen out. Once that side is out other just follows , but you have to feed wire back up headrest shaft to allow a bit of space.
Wire then disconnects from top right hand side of screen - multiplug.
Screen holders are held in with 4 self tappers . Headrest material just stuck approx 5mm all way round.
Once these are out just pull wire back up post & out through oblong hole....Done !!
There is also another screen mount held onto headrest frame by 2 self tappers if you need that !!
Screens are fully enclosed ...nice little shaped units...should all make sense when you have them out
MY17 D5 1st Edition Namib Orange
MY15 D4 HSE Kaikoura Stone
MY12 D4 HSE Nara Bronze Sold and gone
MY11 D4 HSE Stornaway Grey Sold and gone
D3 S spec Silver Sold and gone
Tow bar, full length roof bars, side steps, tow bar storage unit, surround camers.
D4 camera club
|
21st Jan 2016 12:26 pm |
|
|
clubcars
Member Since: 03 Jul 2014
Location: Kent
Posts: 14
|
Perfect. Many thanks for the reply
|
21st Jan 2016 12:50 pm |
|
|
ChrisD3
Member Since: 02 Dec 2012
Location: Hampshire
Posts: 263
|
Club cars Sorry for the delay
Thankfully I see you have been taken care of
Good luck
ChrisD3 2005 D3 SE Auto
|
21st Jan 2016 9:10 pm |
|
|