wallop85
Member Since: 31 Jul 2016
Location: California
Posts: 4
|
Only Suspension on Front Axle on Bump Stops? |
|
New here after many suspension problems lately.
Replaced failed compressor and relay today (brand new) and it raises the rear wheels, but the front two wheels are sitting on the bump stops. There are NO fault codes and no warning lights. And now I am beyond confused. I have not seen this exact issue on any forums or online.
Sprayed for leaks and did not find any.
*To note: the previous failed compressor had fault code of "pressure does not decrease when venting gallery" and "computer module." The LR Dealer also cleared the problem with the car and described that somehow the LR3 put/locked itself into transportation mode. This turned the red warning light to the amber light.
Have any of you come across this issue or have any ideas? Supposed to be moving across country and need this fixed ASAP.
|
31st Jul 2016 8:30 am |
|
|
Marmoset
Member Since: 28 May 2007
Location: Cheshire
Posts: 281
|
It sounds like there might be a valve block problem - the centre one controls front/rear distribution. it should show up on a code reader though?? You could just put a new block on - not sure of the cost but not prohibitively expensive. Also worth checking the wiring to it first - it might be that its not closing due to a signal/feed voltage fault - I had a broken wire on my last D3 causing problems.
What year is yours? the early ones had the connectors under the front left wheel arch liner and they quite often suffered from exposure to the elements. 2011 D4 SDV6 HSE
2008 D3 TDV6 HSE
2005 D3 V8 SE - left in Oz..
|
5th Aug 2016 8:21 am |
|
|