Endeavour
Member Since: 03 Feb 2019
Location: Toronto
Posts: 132
|
IIDTOOL - guide for suspension |
|
All four corners of my LR3 are different heights at standard setting.
I cant select access mode without it lowering and then getting the msg "suspension is in extended mode" and it lifts back up again
Raising from standard to off-road seems ok though.
I have just bought an IIDTool BT and wondered if there was a step by step guide to resetting the suspension heights for each corner?
|
11th Mar 2019 3:05 pm |
|
|
Bodstruck
Member Since: 17 Aug 2017
Location: Wiltshire
Posts: 230
|
There is a guided calibration option in the app. It takes you through the process allowing you to adjust one corner at a time. All you need is a tape measure and somewhere flat to park. You measure from the wheelarch to the centre of the wheel then use the up and down buttons to set it to the measurement displayed on the app (655 front and 685 mm rear I think). Did mine last week and only took about 10 mins.
|
11th Mar 2019 3:48 pm |
|
|