Member Since: 10 Nov 2008
Location: Bomber County
Posts: 4547
U0122 and ABS sensor
Had a fault on the way home which caused the following:
No ABS/DSC
No HDC
No Suspension
No Terrain Response
No Speedo
Had U0122 (Lost Communication With Vehicle Dynamics Control Module) and an ABSSensor on LHR (passenger rear) either open or short circuit, can't remember which.
So I guess I need to check continuity between the connectors at the front under the wheel arch and at the rear where it splits....but has anyone got any more info than this?
Wire colours/numbers, connector locations or anything else I can check?
Cheers 2014 D4 XS
2005 D3 SE - Gone
8th Jan 2014 9:39 pm
Allan_T
Member Since: 10 Sep 2012
Location: Northampton
Posts: 1034
PM sentGAP IID Pro Multi Vehicle Defender L316 2007-2015 - Discovery 3 - Discovery 4 - Discovery Sport L550 - Freelander 2 - Range Rover Evoque L538 - Range Rover L322 - Range Rover L405 - Range Rover Sport L320 - Range Rover Sport L494 Electrical Fault Diagnostics
8th Jan 2014 9:48 pm
J@mes
Member Since: 10 Nov 2008
Location: Bomber County
Posts: 4547
Have tried moving sensors from side to side and the fault stays on the left hand side, have inspected the looms at either end and can't find and corrosion on the wires or connectors.....
Anyone else got any ideas on this one?
2014 D4 XS
2005 D3 SE - Gone
11th Jan 2014 3:12 pm
Robbie
Member Since: 05 Feb 2006
Location: ¯\_(ツ)_/¯
Posts: 17932
ABS or CAN bus issue.
Click image to enlarge
Land Rover - Turning Drivers into Mechanics Since 1948
Member Since: 10 Nov 2008
Location: Bomber County
Posts: 4547
Allan sent me the diagrams and pictures, which was helpful in seeing where everything was but with limited time I haven't been able to find anything today so it's off to the Indi on Monday.
Unfortunately I don't have the time or the inclination (when its been 3*c outside all day) to spend hours around with it
Thanks for the diagram Robbie 2014 D4 XS
2005 D3 SE - Gone
11th Jan 2014 4:52 pm
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20732
Member Since: 10 Nov 2008
Location: Bomber County
Posts: 4547
Had that all to bits, cleaned the wiring looms/connectors up as they were covered in mud.
No signs of corrosion or rubbing on either end of the connectors where it comes out of the copex to the connector block.
2014 D4 XS
2005 D3 SE - Gone
11th Jan 2014 7:22 pm
Disco_Mikey
Member Since: 29 May 2007
Location: Dundee, Scotland
Posts: 20732
Normally, you will find the damaged wire about 3-4 inches from the connector, on the chassis side. More often than not, it will be hidden under the plastic conduitMy D3 Build Thread
You cannot post new topics in this forum You cannot reply to topics in this forum You cannot edit your posts in this forum You cannot delete your posts in this forum You cannot vote in polls in this forum